Abstract:Pumped storage power is the most mature and cleanest energy in the world, which is universally used in energy recovery fields. As the pumped storage units operate at part-load conditions, typical unstable flow phenomena are universally observed. Guaranteeing the operation stability of the unit is being increasing significant. Since much attention has been paid to the unstable flow characteristic in the hump region, the interaction between the unstable flow and hump characteristic is seldom involved. In present research, comprehensive analysis is systematically conducted to explore unstable flow and its interaction with the hump characteristic in a pump-turbine operated at pump mode. Three typical models, corresponding to the test model, small lean angle model (lean angle theta = 2 degrees) and medium lean angle model (lean angle theta = 10 degrees) representing different flow conditions, i.e., "hump peak", "hump valley" and "stable condition" respectively, are selected for analysis. First, characteristic curves predicted by a modified shear stress transport k-omega partially averaged Navier-Stokes model show good agreements with the experiment data. Then, comprehensive discussions are performed in the blade passage of runner and guide vane. In the runner blade passage, the scale of flow separation near the suction side of the blade increases with increment of the lean angle. In the guide vane, although rotating stall is observed in three models, its scale and intensity are largest under the "hump peak" condition, and alleviated under the "hump valley" and "stable condition". After frequency and its dynamics analysis, it is found that one dominant frequency of 0.088f(n) is induced by the rotating stall evolution. Moreover, as the rotating stall is alleviated under the "stable condition", the dominant frequency captured by the proper orthogonal decomposition (POD) method is transferred to 3f(n), and the hump is also alleviated.

Numerical simulation of the pump-turbine s characteristic

Numerical Investigation on the “S” Characteristics of a Reduced Pump Turbine Model

Numerical simulation of instability characteristic in pump turbines

Analysis of the Pump-Turbine S Characteristics Using the Detached Eddy Simulation Method

Numerical Simulation of Hysteresis Characteristic in the Hump Region of a Pump-Turbine Model

Numerical Investigation on the Unstable Flow and Its Interaction with the Hump Characteristic in a Pump Turbine at Pump Mode

Unsteady Simulation and Analysis for Hump Characteristics of a Pump Turbine Model

Numerical analysis on flow in pump-turbine in turbine mode at high flow rates

Numerical Simulation of Flow Characteristics of Pump Turbine with Small Guide Vanes Opening

Numerical Simulation on Pump Transient Characteristic in a Model Pump Turbine

Entropy Production Analysis for S-Characteristics of a Pump Turbine

Numerical investigation of stalled flow in pump turbine under off-design condition

S-shaped characteristics of pump turbine with large guide vane opening by experimental and numerical analysis

Flow characteristics of pump-turbine at turbine braking mode

Numerical investigation of hydraulic instability of pump-turbines in fast pump-to-turbine transition

Characteristics Study of Pump-turbine at Reverse Pump Conditions

Flow of Pump-turbine on S-shaped Region of Complete Characteristics

Numerical Investigation of the Hump Characteristic of A Pump-Turbine Based on an Improved Cavitation Model

Investigate the full characteristic of a centrifugal pump-as-turbine (PAT) in turbine and reverse pump modes

Hydraulic optimization of "S" characteristics of the pump-turbine for Xianju pumped storage plant

Analyzing the S-characteristic of pump-turbine under the same head condition from the perspective of flow energy dissipation