Abstract:When a penetrator with enhanced lateral effect (PELE) impacts on a reinforced concrete (RC) target, the target is damaged with a large opening. An understanding of how PELE projectile parameters affect the opening dimension, is essential for effective design of the PELE projectile. In this study, under the condition that the impact velocity and target parameters (strength and thickness) were fixed values, the important influence factors of the PELE (jacket wall thickness B, jacket material strength <math>Y1</math>, filling material strength <math>Y2</math> and angle of monolithic jacket θ) were determined by a dimensional analysis. Tests and simulations of the PELE penetrating the RC target were conducted to analyze the influence of these factors on opening diameter (<math>D¯</math>, an equivalent diameter under relative kinetic energy). Based on the test and simulation results, it is found that the influence of these factors B, Y1 and θ on the deformation mode of the jacket shows a similar trend: as values of the three factors decrease, the jacket deforms from small bending deformation to large one, and then to curling deformation. This causes the opening diameter to first increase with the decrease of these three factors, and then decreases. It is well known that the bending resistance of the jacket is related to these factors B, Y1 and θ. Therefore, a plastic limit bending moment (M0) of the jacket was quoted to characterize the influence of these factors on the bending deformation of the jacket and the opening diameter of the target. The influence factor <math>Y2</math> causes <math>D¯</math> to first increase with the increase of <math>Y2</math>, and then decreases. A formula was developed to predict the opening diameter, whose influence parameters were considered in a dimensionless way. It has been shown that the dimensionless opening diameter <math>D¯/d1</math> is dependent on two dimensionless parameters <math>Q=d13fcM0</math> and <math>G=fcY2</math>, where <math>d1</math> and <math>fc</math> are the outer diameter of the projectile and the compressive strength of the target, respectively.

Numerical Simulation of the Influence of the Ratio of Inside to Outside Diameter on Lateral Efficiency of PELE

The Influence of Ratio of Length to Diameter on the Penetrator with Enhanced Lateral Efficiency

The Influence of Impact Speed on the Penetrator with Enhanced Lateral Effect

Investigation on the anti-penetration performance of the steel/nylon sandwich plate

Numerical Study on the Perforation of Steel Plates by Multiple Projectiles

Influence of Filling Material Density on Terminal Effect of PELE Projectile

Numerical Study on the Damage Efficiency of Half-Premade Fragmented PELE

Numerical Simulation of PELE Penetrating Composite Armor

Numerical simulation of the disk fragment impacting resistance of plate target

Influence of Impact Angle on the Lateral Efficiency of PELE

Lateral enhancement effect of reactive PELE: Two-step segmented simulation and analytical modeling

Fragmentation Characteristics and Damage Capacity of Radial Layered PELE

Effect of Projectile Rotation Rate on Lateral Effect of PELE Penetrating Reinforced Concrete Target

Numerical Simulation On The Interference With High Velocity And Flat Head Penetrator By Lefp

Influence of Block Structure on Lateral Effect of PELE

Oblique Penetration of a Circular Pipe Target by a Prefabricated Fragment

Perforation Characteristics of Metal Target Plate Subjected to PELE

Fragmentation Behaviour of Radial Layered PELE Impacting Thin Metal Target Plates

Effect of projectile parameters on opening behavior of PELE penetrating RC target

Analytical investigation on deformation of PELE projectile and opening damage to concrete target

Opening behavior of PELE perforation on reinforced concrete target