Abstract:Most of the existing studies on acid corrosion of concrete have focused on the mechanical behavior of concrete structures under monotonic load or without load. To investigate the mechanical properties of in-service concrete components under cyclic load in an acid corrosion environment, six groups of concrete prism specimens with different acid corrosion degrees (corrosion duration) were designed and prepared by the accelerated corrosion test method. The monotonic and cyclic axial compression load tests on these specimens were conducted to investigate the effects of corrosion degree on the mechanical properties of concrete specimens. The experimental results indicated that hydrochloric acid corrosion has obvious effects on the failure characteristics and mechanical properties of concrete. The surface of corroded concrete was easier to crack and spall under load, and the concrete spalling area enlarged as the acid corrosion duration increased. The compressive capacity of concrete specimens reduced rapidly with the increase in corrosion duration. The stress–strain envelope curves for concrete with different corrosion duration under cyclic load were essentially similar to that of concrete under monotonic load. The degradation rate of the descending section for the stress–strain curves of corroded concrete under cyclic load was much larger than that under the monotonic load due to the accumulation of internal damage in concrete. The peak strain and ultimate strain of corroded concrete increased significantly with the increase in corrosion duration and enhanced by 55.7% and 77.9%, respectively, compared with the uncorroded concrete, whereas the peak stress and elastic modulus rapidly decreased and reduced by 53.3% and 74.1%, respectively. Moreover, based on the strength degradation depth, the concept of effective bearing cross-sectional area ratio was proposed to characterize the corrosion degree of concrete, and the correction coefficient of descending section for the effective bearing cross-sectional area ratio was introduced to establish the constitutive model of corroded concrete under cyclic load, and the results calculated by this model matched well with the experimental values. The research in this paper can provide the experimental and theoretical basis for seismic life cycle and fatigue redesign of concrete structures in acid corrosion environments or coastal areas.

Experimental Study on Compressive Property of Concrete Corroded by Seawater in Low-Temperate

Study on dynamic compression properties of ultra-high toughness cementitous composites under cyclic wetting and drying of salt spray

Corrosion-Induced Cracking Propagation Of Rc Beams Subjected To Different Corrosion Methods And Load Levels

Experimental Study of the Modulus of Steel Corrosion in a Concrete Port

Monotonic and fatigue behavior of steel-concrete composite beams subjected to corrosion

EXPERIMENTAL INVESTIGATION AND DESIGN OF SEVERELY CORRODED REINFORCED CONCRETE BEAMS

Performance of Reinforced Concrete Beams Corroded under Sustained Service Loads: A Comparative Study of Two Accelerated Corrosion Techniques

Corrosion-induced Shear Performance Degradation of Reinforced Concrete Beams

Study on Mechanical Properties and Constitutive Relationship of Concrete Corroded by Hydrochloric Acid under Cyclic Load

Effect of Chloride-Induced Reinforcing Steel Corrosion on the Flexural Strength of Reinforced Concrete Beams

Study on Mechanical Properties of Steel-Concrete Composite Beam with Corroded Studs Under the Effect of Negative Bending Moment

Mechanical Performance of Corroded Steel Bars in Concrete

Prediction of Concrete Compressive Strength in Saline Soil Environments

Accelerating Tests For The Performance Deterioration Of Concrete Exposed To Chloride Media

Experimental investigation of composite steel-concrete beams with corroded studs

Static and Fatigue Behavior of Steel-Concrete Composite Beams with Corroded Studs

Applicability Study on Accelerated Corrosion Methods of Steel Bars in Concrete Structure

Chloride penetration in concrete under marine atmospheric environment – analysis of the influencing factors

Behavior of Reinforced Concrete Subjected to Boric Acid Corrosion of Nuclear Power Plant

Effect of Corrosion on Bond Behavior and Bending Strength of Reinforced Concrete Beams

Experimental Study and Mechanism Analysis on Frost Resistance of Normal Performance Concrete under Different Environments