Technology for CNP1000 shaft sealed reactor coolant pump
Xiaodong FENG,Dazhuan WU,Lifeng YANG,Yun JIA
DOI: https://doi.org/10.3969/j.issn.1674-8530.15.0162
2016-01-01
Abstract:As high-end equipment in pump industry , CNP1000 shaft sealed reactor coolant pump ( RCP) in the primary loop system of pressurized water reactor ( PWR) in a nuclear power plant is the only equipment which cannot be manufactured domestically .Therefore, the independent design , ma-nufacturing and test of this kind of pump are important and difficult tasks in promoting the nationaliza-tion of nuclear technology in China .The domestic technological situation and structural characteristics of 1 000 MW shaft sealed RCP are introduced , and the design principle and technical implementation requirement are elaborated in terms of pressure retaining boundary , hydraulic components , pump rotor system, heat insulation subassembly , shaft seal, standstill seal, lower guide bearings, thrust bearing, integrated oil pump , oil seal, auxiliary system and key equipment in detail .Through an analysis on ex-port restriction and application prospect of various types of RCP , it is shown that shaft sealed RCP has more strength in export and will occupy a dominant position in the nuclear equipment market for a long time.Presently, several key technologies, such as shaft seal, hydraulic components, and full-load test have been nationalized in a few domestic factories , but the theoretical principle of RCP is still not well established and needs to be explored further .Hence , as an important mission , the nationalization of RCP still requires a long time to be tackled .