Influence of Natural Ester on Thermal Aging Characteristics of Oil–paper in Power Transformers

Lijun Yang,Ruijin Liao,Caixin Sun,Huigang Sun
DOI: https://doi.org/10.1002/etep.398
2010-01-01
European Transactions on Electrical Power
Abstract:The cellulosic insulation used in electrical transformers was aged in mineral oil and natural ester to investigate the influence of oil type on the thermal aging properties of oil paper. Accelerated aging tests were conducted at three different temperatures and the degree of polymerization P) of insulation paper was measured to indicate the extent of aging of the paper. Various aging characteristics in oil, i.e., furfural, CO, CO2, water incentration, and oil acidity, were measured during the aging processes. Kinetic models of cellulose degradation in mineral oil and natural ester re established. The correlations between DP and various aging by-products were also included in our investigation. The results indicate that per degraded at a significantly faster rate in mineral oil than in natural ester. A leveling off degree of polymerization (LODP) was observed during thermal aging process. Once the LOOP was reached, the aging rate became very slow. Paper impregnated with natural ester has a higher LOOP in paper impregnated with mineral oil, so that a longer time is needed to reach its end-of-life (DP approximate to 250). In addition, the content of degradation-products of insulation paper aged in natural ester was very different from that aged in conventional transformer oil. Thus special attention must paid when applying conventional diagnostic criteria to aging of composite insulation impregnated with natural ester. Copyright (C) 2009 John Viley & Sons, Ltd.
What problem does this paper attempt to address?