Abstract:We focus on the parameter identification of doubly fed induction generator （DFIG} based wind turbine generator （WTG）. Firstly, the trajectory sensitivity analysis is used to make judgments about the identifiability of parameters. If the phases of sensitivity curves are not the same or reverse, the parameters are uniquely identifiable. By this theory, we find that the stator reactance and rotor reactance cannot be simultaneously identified, but the other parameters are uniquely identifiable. Secondly, the difficulty of identification which means the possibility of obtaining the accurate values o{ the parameters from the measurement data is analyzed. A parameter is easy to be identified if the sensitivities of both time-domain and frequency-domain are high. A parameter which has a high value only in the low frequency area of the frequency-domain sensitivity curve is relatively easy to be identified. It is found that the stator reactance, rotor reactance, and exciting reactance are easy to be identified; the stator resistance and rotor resistance are relatively easy to he identified; the inertial constant is difficult to be identified. According to the analysis of identifiability and the difficulty of identification, four key parameters including the stator resistance, stator reactance, exciting reactance, and rotor resistance are decided to be identified. Then, an ant colony optimization algorithm based identification method is designed. Finally, the correctness of the analysis and the efficiency of the identification method are validated by the simulation results obtained in Matlab/Simulink environment.

Model Parameters Identification Method for Wind Farms Based on Wide-Area Trajectory Sensitivities

Parameter identification of drive system for fixed-speed wind power generation units

System Wide Parameter Identification of Multi-generators in Power Systems

Model parameter identification of DFIG based on short circuit current

Probabilistic Preassessment Method of Parameter Identification Accuracy with an Application to Identify the Drive Train Parameters of DFIG

Transfer Function Based Equivalent Modeling Method for Wind Farm

Online Identification of Static Characteristic Coefficients of Wind Farm Based on Small Disturbances

Parameter Identification of Load Model Using Scatter Plot Based Global Sensitivity Analysis

A Two-step Method for Estimating DFIG Parameters in a Wind Turbine and the Measurement Selection

Analysis on the Identification of Doubly Fed Induction Generator

Distinguishability Analysis of Controller Parameters with Applications to DFIG Based Wind Turbine

Comprehensive Modeling and Parameter Identification of Wind Farms Based on Wide-Area Measurement Systems

Parameter identification of three-mass drive-train system for fixed-speed wind turbine generator based on PSO algorithm

Wind Farm Power Optimization Using System Identification

Network Parameter Identification and Estimation Based on Hybrid Measurement of WAMS/SCADA

Modeling Principle and Parameter Identification of Double Fed Wind Turbine for Electromechanical Transient Simulation of Power System

Multistage Parameter Identification Featured Generic Wind Farm Dynamic Equivalent Modeling

A Load Parameter Identification Method Based on Wide Area Measurement

A Load Modeling Method Based on Wide Area Trajectory Sensitivity

Multi-scenario parallel interior algorithm for generator parameter identification in power systems

Parameters Identification of Equivalent Model of Permanent Magnet Synchronous Generator (PMSG) Wind Farm Based on Analysis of Trajectory Sensitivity