Abstract:The correct electric power fluctuation process of a wind farm is essential for the operation and studying of the power grid integrated with wind power. A complete wind energy conversion model, that should take both the spatial effects and the overall effect of all the pitch angle controllers into account, is required to convert the wind fluctuation into the electric power fluctuation. Although some equivalent models have been proposed in previous studies, there is no simple solution for equivalently modeling the non-synchronous actions of the pitch angle controllers in individual wind turbine generators. This study found the relationship between the overall effect of all the pitch angle controllers and the spatial effects of the wind farm and presented a theoretical derivation of the frequency-domain equivalent modeling method. The proposed modeling method is the simplest way to obtain the equivalent model of the complete wind energy conversion process of a wind farm with consideration of all the spatial effects and the overall effects of all the pitch angle controllers. The only input signal of the proposed equivalent model is the speed of the wind before entering the wind farm, which is called the "original incoming wind speed" and the only output signal is the total power of the wind farm. In this proposed equivalent modeling method, a discrete transfer function for representing both the wind energy conversion process, and all the spatial effects of a wind farm, can be obtained, first through a wind process below the rated wind speed. Second, a compensation factor for calculating a "compensation wind speed" of the original incoming wind can be obtained through a wind process that partly exceeds the rated wind speed. Using this compensation wind speed, a compensation power with negative values can be obtained to represent the total reduced power caused by the pitch angle controllers in individual wind turbine generators. A frequency-domain equivalent model has been identified and validated by field measurements of an actual wind farm. The normalized root-mean-squared error of the model is less than 8% over the entire wind process, and the maximum error of the power ramp rate in 10 min is less than 5 MW. Finally, an example is provided to demonstrate the online use of the proposed model to convert the forecasted wind speed into output power of a wind farm in ultrashort-term wind power forecast.

Comprehensive Modeling and Parameter Identification of Wind Farms Based on Wide-Area Measurement Systems

Transfer Function Based Equivalent Modeling Method for Wind Farm

Online Identification of Static Characteristic Coefficients of Wind Farm Based on Small Disturbances

System Wide Parameter Identification of Multi-generators in Power Systems

Equivalent Modeling of Wind Energy Conversion Considering Overall Effect of Pitch Angle Controllers in Wind Farm

Electric Load Modeling for Wide Area Power Systems

Equivalent modeling of wind farm in frequency domain

Parameter identification of drive system for fixed-speed wind power generation units

Load Modeling for Wide Area Power System

Modeling of Wind Speeds Inside a Wind Farm With Application to Wind Farm Aggregate Modeling Considering LVRT Characteristic

Model Parameters Identification Method for Wind Farms Based on Wide-Area Trajectory Sensitivities

Wind Farm Power Optimization Using System Identification

Common Mode Frequency Analysis Modeling and Quantification Method for Power System with High Penetration of Renewable Energy Generation

Multistage Parameter Identification Featured Generic Wind Farm Dynamic Equivalent Modeling

Network Parameter Identification and Estimation Based on Hybrid Measurement of WAMS/SCADA

Modeling Principle and Parameter Identification of Double Fed Wind Turbine for Electromechanical Transient Simulation of Power System

Intelligent Parameter Design-Based Impedance Optimization of STATCOM to Mitigate Resonance in Wind Farms

Wide-area measurement system based power load modeling

Enhanced Frequency and Voltage Support of Wind Farms with Energy Storage Systems for the Power Grid

Stability Analysis based on Parameter Sensitivity for Large-Scale Renewable Energy Bases Considering Frequency Coupling Characteristic

Modelling and Controlling of SCES Based Wind Farm Power Regulation System