Abstract:In this article, the partial discharge (PD) excitation characteristics of SF 6 /N 2 gas mixtures on the epoxy insulation surface under AC/LI (Alternating Current and Lightning Impulse) superimposed voltages are investigated. The phenomenon of PD excitation in SF 6 /N 2 gas with 20% SF 6 content is explained in detail. The effects of SF 6 /N 2 gas mixtures ratio and the polarity on the PD characteristics under subsequent AC voltage are analyzed. It found that under the influence of AC/LI superimposed voltages, there are significant differences in the PD initiation characteristics between SF 6 /N 2 gas with SF 6 content less than 60% and pure SF 6 . In SF 6 /N 2 gases, the AC superimposed phase that can initiate subsequent discharge is larger, and when superimposed voltages is applied in the positive (or negative) half-cycle of AC to initiate discharge, in pure SF 6 , the discharge only occurs in the subsequent AC’s negative (or positive) half-cycle. However, in SF 6 /N 2 gas mixtures with SF 6 content less than 60%, the discharge can occur in both the positive and negative half-cycles of AC. In addition, the PD phenomenon after AC/PLI superimposed voltages is more prominent than AC/NLI superimposed voltages. The severity of PD under subsequent AC increases with the decrease of AC voltage duration experienced from the superposition moment to the first zero crossing point of the AC voltage.

Effect of Electronegative Gas on Partial Discharge Characteristics

Study On The Partial Discharge Characteristics In Different Solid And Gaseous Dielectric By Simulation

Influence of Gas Flow on Partial Discharge Behaviors in Air and Nitrogen

Effect of O2 on AC Partial Discharge and Decomposition Behavior of C4F7N/CO2/O2 Gas Mixture

Effect of Artificial Void Area on Partial Discharge Characters

The Effect of Surface Charge Decay on Variation of Partial Discharge Location

Partial Discharge Characteristics in the Course of Aging Within XLPE Insulation

Partial Discharge Characteristics of Amorphous Polymer Caused by Void Defect

Influencing Factors on Characteristics of Partial Discharge in Void of Insulating Materials

Partial Discharge Characteristics of SF6 and SF6/N2 in Nonuniform Electric Field under Negative DC Voltage

Variation of surface charge distribution in PD sequences

Excess conduction induced by partial discharge in polymer

Variation of Surface Charge Distribution in the Process of PD Degradation

Effects of Partial Discharge under Square Pulse Voltage on Lifetime of Polyimide Film

Size Effect of Partial Discharge in Solid Void Defects

Partial discharge characteristics of oil/polypropylene film with a needle-plate electrode excited by impulse voltages

Partial Discharge Characteristics Study of Composite Insulating Materials in Thermo Oxidative Ageing

Partial discharge characteristics of epoxy insulation surface under AC/LI superimposed voltages in SF<sub>6</sub>/N<sub>2</sub> gas mixtures

Partial Discharge Characteristics and Mechanism in Voids at Impulse Voltages

Influence of Epoxy Resin on Partial Discharge Development under Non-uniform Field

Effect of PD on the Insulating Paper and Pressboard