Abstract:Described were two types of secondary air structure,i.e. horizontally arranged rod type and vertically arranged pillar type,both of which are located in the center of a furnace. On a cold-state circulating fluidized bed (CFB),the influence of the arrangement pattern,height and secondary air flow rate of the centered secondary air on the particle concentration distribution along the height direction inside the bed was studied and compared with that of the conventional wall-surface secondary air at the same height. It has been found that after the division of air into stages,the particle concentration below the staged secondary air increases with an increase of the secondary air flow rate. An increase in the secondary air height will be accompanied by the dense-phase zone at the bottom extending upwards. Among the secondary air arrangement patterns,the horizontal rod type secondary air arrangement pattern can make the concentration at the bottom attain a maximal value. A trajectory tracking of the jet flow shows that when the secondary air speed is high,the centrally located secondary air can be diffused to the wall-surface zones,but in the central area there is a lack of secondary air. This is unfavorable for the oxygen replenishment to the central area. The horizontal rod type centered secondary air jet flow,however,will swerve and deflect under the action of a lateral momentum when it enters into the bed and can form a relatively large diffusion area. The authors have also mentioned the problems meriting attention and requiring solutions when the centered secondary air is further applied in practical CFB boilers.

Experimental Research on the Corner Secondary Air Injection of Square Circulating Fluidized Bed

Gas-Solids Flow Properties of a Square Circulating Fluidized Bed with Secondary Air Injection

Experimental Study on the Penetration Model of Secondary Air Injection in CFB

Multi-scale Characteristics and Gas-Solid Interaction among Multiple Beds in a Dual Circulating Fluidized Bed Reactor System

Numerical Simulation Of The Gas-Solid Flow In A Square Circulating Fluidized Bed With Secondary Air Injection

Experimental research on solids oscillation circulation behavior in circulating fluidized bed

Design and Experimental Study of the Centrally-located Secondary Air of a Circulating Fluidized Bed

Experimental Study on Secondary Air Mixing along the Bed Height in a Circulating Fluidized Bed with a Multitracer-Gas Method

Experimental study on secondary air mixing along the bed height in a CFB with a multi-tracer-gas method

The Effect Of Lateral Secondary Air Injection On Gas-Fuel Mixing And Coal Combustion Of Cfb Boiler

The Effect of the Secondary Air Injection on the Gas–solid Flow Characteristics in the Circulating Fluidized Bed

Experimental Investigation on Flow Asymmetry in Solid Entrance Region of A Square Circulating Fluidized Bed

Measurements on the Local Solids Concentration in the Lower Part of a Circulating Fluidized Bed Riser

Bottom Zone Flow Properties of a Square Circulating Fluidized Bed with Air Staging

Numerical Study of Particle Injection into a Gas-Solid Fluidized Bed

Effect of Different Nozzle Arrangements on Gas–solid Flow Characteristics of a New Air Distribution System Circulating Fluidized Bed

Experimental Investigation on Local Particle Volume Fractions Distribution in Offset-Exit Circulating Fluidized Bed

Influence of Internals on Gas-solid Flow Behavior in Square-section Circulating Suspension Bed

Experimental Study of the Effect of Internals on Optimizing Gas–solid Flow in a Circulating Fluidized Bed

Dynamic Characteristics of Solids Circulation Establishment in Laboratory and Industrial Circulating Fluidized Beds with Sweeping Bend Return

Experimental Investigation On Secondary Air Jet Penetration Depth In The Dense Zone Of A Circulating Fluidized Bed