Abstract:While recovering methane (CH4), the exploitation of natural gas hydrates (NGHs) with replacement by carbon dioxide (CO2) can result in sequestering of the greenhouse gas CO2 underground and the generation of CO2 hydrates in reservoirs. This replacement process enhances the mechanical properties while preventing the reservoirs from becoming unstable. Methane hydrate-bearing sediment (MHBS) samples with different initial hydrate saturations were prepared by the in situ formation method. By carrying out replacement experiments with CO2 and triaxial compression tests of separate replacement degrees, this research determined the mechanical properties of the samples after replacement and established the strength criterion of NGH reservoirs under CO2 replacement conditions. The results demonstrate that the stress-strain curves of the hydrate-bearing sediment (HBS) samples before and after replacement are hyperbolic and show strain-hardening characteristics, and plastic failure without clear peak strength occurs in all samples. Within the replacement duration of 0–20 h, the replacement ratio has a change whose absolute value less than 1.65% affected by effective confining pressure, and decreases by 8.70%–21.15% with the increase of initial hydrate saturation from 13% to 38%. As the effective confining pressure and the replacement ratio rise, the mechanical parameters of HBS samples change approximately linearly; For the MHBS sample with effective confining pressure of 1 MPa and initial hydrate saturation of 13%, after the replacement ratio reaches 0.69, the stiffness and strength of the sample increase by 29.44% and 30.84% respectively, and the Poisson's ratio decreases by 10.51%. The initial hydrate saturation and replacement ratio mainly influence the failure strength by affecting the cohesion of the HBS samples. The calculated curves based on the established strength criterion are in good agreement with the experimental results, with a relative error of 0.29%–6.18%.

Study on Shear Strength of Artificial Methane Hydrate

Role of Mechanical Deformation in the Thermal Transport of Si-Type Methane Hydrate.

Strengthening and Weakening of Methane Hydrate by Water Vacancies

Experimental research on the mechanical properties of methane hydrate-bearing sediments during hydrate dissociation

Strength and Wear Behaviors of Methane Hydrate-Bearing Silty Sand: Insights from Multi-Reversal Direct Shear Tests

Theoretical insight into thermal transport and structural stability mechanisms of triaxial compressed methane hydrate

Strength behaviors of CH4 hydrate-bearing silty sediments during thermal decomposition

Experimental Investigation on Methane Hydrate-Bearing Sediment Permeability under a Wide Range of Conditions

Experimental Study of Uniaxial Compressive Strength of Gas Hydrate-Bearing Sediment at Constant Strain Rate

Mechanical Properties of a Structure I CO2–CH4 Heteroclathrate Hydrate: Insight from Molecular Dynamics Simulations

Undrained triaxial tests on water-saturated methane hydrate–bearing clayey-silty sediments of the South China Sea

Mechanical Properties and Strength Criterion of Clayey Sand Reservoirs During Natural Gas Hydrate Extraction

Mechanical properties and constitutive model of high-abundance methane hydrates containing clayey–silt sediments

Fracture mechanics of methane clathrate hydrates

Experimental Measurements of Mechanical Properties of Carbon Dioxide Hydrate-Bearing Sediments

Experimental Study on the Mechanical Properties of Sediments Containing Ch4 and Co2 Hydrate Mixtures

Effects of methane-carbon dioxide replacement on the mechanical properties of natural gas hydrate reservoirs

Numerical Simulation of Direct Shear Tests on Gas Hydrate-Bearing Sediments Using the Discrete Element Method

Geomechanical Properties of Deep-Sea Pore-Filled Methane Hydrate-Bearing Soils at Critical State Using DEM Analysis

Structural Stability of Methane Hydrate at High Pressures

An Experimental Study from the South China Sea