Performance Calculation of Single Effect Absorption Heat Pump Using LiBr + LiNO3 + H2O As Working Fluid

Sun Jian,Fu Lin,Zhang Shigang
DOI: https://doi.org/10.1016/j.applthermaleng.2010.07.018
IF: 6.4
2010-01-01
Applied Thermal Engineering
Abstract:In order to check the theoretical performance of the new working fluid LiBr + LiNO3 + H2O (mole ratio of LiBr and LiNO3 = 4:1), the theoretical coefficients of performance (COP) of this working fluid and LiBr + H2O were calculated at various operating conditions. The improvement of crystallization problem was also checked. This proposed working fluid was proved to increase the COP by about 5% than LiBr + H2O. The cooling water through absorber and evaporator was heated to higher temperature by this new working fluid. LiBr + LiNO3 + H2O was found to be an alternative to the conventional LiBr + H2O with higher COP and less corrosivity. Crown Copyright (C) 2010 Published by Elsevier Ltd. All rights reserved.
What problem does this paper attempt to address?