Abstract:<p>High-precision aspheric negative plastic lenses are widely used in optical systems owing to their excellent performance and ease of high-efficiency manufacturing. The imaging performance of the lens is difficult to control, because it is unable to perform optical measurements directly and is sensitive to manufacturing processing meanwhile. Generally, the imaging performance is guaranteed by a strict control of geometrical deviation, such as Peak-to-Valley (PV) and Root-Mean-Square (RMS). In this study, an optical ray-tracing algorithm with the measured geometrical deviation data is proposed to perform an imaging performance analysis correlated with geometrical deviation for the injection molded high-precision aspheric negative plastic lens. Taguchi experiments are applied to investigating the effect of processing parameters. The geometrical deviation of the convex surface is found to be an order of magnitude greater than that of the concave surface. The geometrical dimension of the concave surface is mainly determined by the machining precision of the mold cavity surface, whereas the convex surface dimension is mainly affected by the lens shrinkage. However, the imaging performance has a nonlinear correlation with the geometrical deviation. Modulation Transfer Function (MTF) and Spot Diagram are equivalently affected by the concave and convex geometrical deviations, and depend on the object field height. The effect of processing parameters on geometrical deviation and imaging performance is uncorrelated. Thus, the imaging performance should be simultaneously considered as a criterion as well as the geometrical deviation in the optimization of aspheric negative lens injection molding processing. The imaging performance prediction using an optical ray-tracing algorithm with the measured geometrical deviation data is instrumental to optimize the manufacturing processing.</p>

Compensation Ability Evaluation of Part-Compensation Lens Based on Slope Asphericity

Research of precision interference locating method for a partial null compensator at aspheric testing

The wavefront aberration analysis and testing accuracy evaluation for the large aberration aspheric system based on the best fit sphere - art. no. 68342V

The Wavefront Aberration Analysis and Testing Accuracy Evaluation for the Large Aberration Aspheric System Based on the Best Fit Sphere

Simulation Of Aspheric Tolerance With Polynomial Fitting

Non-null interferometric aspheric testing with partial null lens and reverse optimization

Reverse Optimization Reconstruction of Aspheric Figure Error in a Non-Null Interferometer

Study on testing larger asphericity in non-null interferometer - art. no. 68340T

Measurement of Aspheric Surface

Spherical Aberration Compensation Method for Long Focal-Length Measurement Based on Talbot Interferometry

System Optimization of Radial Shearing Interferometer for Aspheric Testing

Pose-varied Swing Arm Profilometer Test for Off-Axis Aspheric Surfaces with Strong Asphericity

Simulation of Convex Aspherical Surface Testing with Partial Compensating Interferometer

Novel Algorithm for Compensating Misalignment in Optical Spherical Surface Testing

Retrace Error Correction for Non-Null Testing of Optical Aspheric Surface

Numerical Analysis of Compound Aspheric Lens Design and Fabrication

Mixed compensation for the testing of large convex aspheres

Contact lens design with slope-constrained Q-type aspheres for myopia correction

An imaging performance analysis method correlated with geometrical deviation for the injection molded high-precision aspheric negative plastic lens

Method to Design Two Aspheric Surfaces for a Wide Field of View Imaging System with Low Distortion

A New Approach for Tolerance Sensitivity Reduction in Lens Optimization by Controlling the First Order Derivatives of Real Ray Height on Pupil