Abstract:The Laser Doppler Vibrometry (LDV) can continuously measure the speed, acceleration and other parameters of the micro-vibration target. However, with the increase of the surface roughness and the decrease of the diffuse reflectance of the measured object, or the increase of the measurement distance, the laser echo energy will decrease rapidly according to the basic theory of optical propagation. The typical laser doppler vibration measurement technology is based on the principle of two-beam heterodyne interference. However, due to the limitation of the optical device, the third beam, namely the system stray light, from multiple optical devices in the optical path, is inevitable, and has a certain intensity and phase distribution. The system stray light will seriously nonlinear suppress the vibration phase signal of the micro-vibration target. To reduce the system stray light, methods like surface coating, tilt design and curved lens design are employed, but it greatly affects the detection signal-to-noise ratio and micro-vibration detection capability of the system. In this paper, a method based on four-wave hybrid interference to eliminate stray light is proposed. A calibration laser beam is added to the original interference optical path. With measurement on the system stray light, the laser external modulation is used to make the intensity, frequency and phase of the calibration beam vary with the parameters of the system stray light. The influence of stray light in the system can be theoretically eliminated if the intensity and frequency of the calibration beam is consistent with the stray light, and the initial phase difference is .

Eliminating Noises Contained in Sensing Signals from a Self-Mixing Laser Diode

Analysis of Noises and Method of Reducing the Noises in Optoelectronic Detectors

Optimization of the Laser Vibrometer Based on the Self-Mixing Effect in a Diode Laser

Abnormal Intensity Noises of LD-pumped Microchip Nd∶ YAG Laser

EMD Filter Algorithm for Self-Mixing Interference Displacement Sensor

Principles, Measurements and Suppressions of Semiconductor Laser Noise-A Review

Study on Noise Reduction of Tunable Diode Laser Absorption Spectroscopy Detection Signal Based on Complete Ensemble Empirical Mode Decomposition with Adaptive Noise-Detrended Fluctuation Analysis-Wavelet Soft Threshold

Research on LDV stray light suppression technology based on four-wave hybrid interference

Research on a System Noise Simulation and Filtering Method in Tunable Diode Laser Absorption Spectroscopy Technology

Efficient Suppression of the Laser Speckle in the Laser Projection System

Sensing by Dynamics of Lasers with External Optical Feedback: A Review

Self-mixing velocimeter using an edge emitting laser

The Elimination of Laser Liquid-Level Measurement Signal Fluctuation Based on the LMS Adaptive Noise Cancellation

All-Fiber Laser-Self-Mixing Sensor for Acoustic Emission Measurement

Self-Mixing Interference in Dual-Polarization Microchip Nd:YAG Lasers

Sub-external Cavity Effect and Elimination Method in Laser Self-Mixing Interference Wave Plate Measurement System

Mitigation of Amplified Spontaneous Emission Noise for an All-Fiber Coaxial Aerosol Lidar with Different Single-Photon Detectors

A Laser Diode Driving Board with Precise Temperature Control Circuit for MDI-QKD Experiment

Achieving high sensing resolution using a Microwave Photonic Signal generated by a laser diode with a control cavity

High-Power Quantum-Limited Photodiode and Classical Laser Noise Squashing

Research on laser spot location accuracy of low-power laser diode source applied to high precision laser measurement system