Abstract:A 1550 nm all-fiber dual-polarization coherent Doppler lidar (DPCDL) was constructed to measure the depolarization ratio of atmospheric aerosols. In lidar systems, the polarization state of the laser source is typically required to be that of linearly parallel polarization. However, due to the influence of the fiber-optical transmission and the large-mode field output of the telescope, the laser polarization state changes. Hence, a polarizer was mounted to the emitting channel of the telescope to eliminate the depolarization effect. A fiber-optical polarization beam splitter divided the backscattered light into components with parallel and perpendicular polarization. The DPCDL used two coherent channels to receive each of these two polarization components. A calibration procedure was designed for the depolarization ratio to determine the differences in gain and non-responsiveness in the two polarization channels. The calibration factor was found to be 1.13. Additionally, the systematic error and the measured random error of the DPCDL were estimated to evaluate the performance of the system. The DPCDL’s systematic error was found to be about 0.0024, and the standard deviation was lower than 0.0048. The Allan deviations of a 1-min averaging window with a low SNR of 19 dB and a high SNR of 27 dB were 0.0104 and 0.0031, respectively. The random errors at different measured heights were mainly distributed below 0.015. To confirm the authenticity of the atmospheric depolarization ratio measured with the DPCDL, two field observations were conducted with the use of a co-located DPCDL and micro-pulse polarization lidar to perform a comparison. The results showed that the correlation coefficients of the aerosol depolarization ratios were 0.73 and 0.77, respectively. Moreover, the two continuous observations demonstrated the robustness and stability of the DPCDL. The depolarization ratios were detected in different weather conditions.

Mitigation of Amplified Spontaneous Emission Noise for an All-Fiber Coaxial Aerosol Lidar with Different Single-Photon Detectors

Optimization of System Design and Calibration Algorithm for SPAD-Based LiDAR Imager

Compact And Lightweight 1.5 Mu M Lidar With A Multi-Mode Fiber Coupling Free-Running Ingaas/Inp Single-Photon Detector

Compact and lightweight 1.5 μ m lidar with a multi-mode fiber coupling free-running InGaAs/InP single-photon detector

Micro-pulse Polarization Lidar at 15 Μm Using a Single Superconducting Nanowire Single-Photon Detector

Compact and lightweight 1.5 μm lidar with a multi-mode fiber coupling free-running InGaAs/InP single-photon detector

The Design and Performance Evaluation of a 1550 Nm All-Fiber Dual-Polarization Coherent Doppler Lidar for Atmospheric Aerosol Measurements

Calibration and Improved Speckle Statistics of IM-CW Lidar for Atmospheric CO2 Measurements

Detection performance improvement method of single-photon LiDAR by the combination of speckle suppression with adaptive adjustment of aperture diameter and spatial correlation method

Angle-Dependent Quantum Efficiency Correction for Improved Signal Accuracy in Small-Scale Scheimpflug Lidar Systems

A new Lidar technology using frequency comb light source

Lidar with Superconducting Nanowire Single-Photon Detectors: Recent Advances and Developments

Photon-counting Chirped Amplitude Modulation Lidar System Using Superconducting Nanowire Single-Photon Detector at 1550-Nm Wavelength

Stratospheric aerosol lidar with a 300 µm diameter superconducting nanowire single-photon detector at 1064 nm

Single-photon Lidar for Canopy Detection with a Multi-Channel Si SPAD at 1064 Nm

Improving the Signal-to-noise Ratio of GM-APD Coherent Lidar System Based on Phase Synchronization Method

All-fiber Multifunction Differential Absorption CO2 Lidar Integrating Single-Photon and Coherent Detection

Fast Retrieval of Atmospheric CO2 Concentration Based on a Near-Infrared All-Fiber Integrated Path Coherent Differential Absorption Lidar

Design of Lidar Data Acquisition and Control System in High Repetition Rate and Photon-Counting Mode: Providing Testing for Space-Borne Lidar

Simulation of Compact Spaceborne Lidar with High-Repetition-Rate Laser for Cloud and Aerosol Detection under Different Atmospheric Conditions.

Fully integrated free-running InGaAs/InP single-photon detector for accurate lidar applications