Abstract:To bring the potential power of the capacitively coupled contactless conductivity detection ((CD)-D-4) technique to full play and extend the application fields of (CD)-D-4, our previous work has developed a (CD)-D-4 sensor which is suitable for conductivity detection of electrolyte solution in industrial fields (Sensors and Actuators A 213 (2014) 1-8). With the introduction of series resonance principle, the (CD)-D-4 sensor can overcome the influence of coupling capacitances on conductivity measurement. By a specific design of shield configuration, the (CD)-D-4 sensor can overcome the influence of stray capacitances and the environment interference in industrial fields. Although the measurement performance of the (CD)-D-4 sensor is satisfactory and it is suitable for the conductivity detection in industrial fields, the input-output characteristic of the (CD)-D-4 sensor is non-monotonic, which may limit the practical applications of the (CD)-D-4 sensor. To overcome this drawback, an improved (CD)-D-4 sensor for conductivity detection in industrial fields has been developed. The basic conductivity measurement method (the series resonance principle) and the shield configuration of the improved (CD)-D-4 sensor are the same as those of the (CD)-D-4 sensor in our previous work. However, the measurement circuit of the detection path of the improved (CD)-D-4 sensor has been optimized. The one-inductor design has been replaced by a two-inductor design. With this optimization, the input-output characteristic of the improved (CD)-D-4 sensor is theoretically monotonic. Conductivity measurement experiments were carried out on four pipes with inner diameters of 1.8 mm, 3.3 mm, 5.0 mm and 7.6 mm, respectively. The experimental results indicate that the development of the improved (CD)-D-4 sensor is successful. In comparison with the previous (CD)-D-4 sensor, the measurement accuracy of the improved (CD)-D-4 sensor is comparable. But, the improved (CD)-D-4 sensor has the advantages of the monotonic input-output characteristic and the convenience for practical conductivity detection in industrial fields. Meanwhile, it is found that the input-output characteristic of the improved (CD)-D-4 sensor is nonlinear and the sensitivity of the improved (CD)-D-4 sensor decreases with the increase of conductivity. (C) 2015 Elsevier B.V. All rights reserved.

Wireless monitoring system using novel capacitive sensor

[Development of a Wireless Multiple Physiological Parameters Monitoring System].

New Contactless Conductivity Detection (CCD) Sensor for Fluid Conductivity Measurement

Capacitively Coupled Contactless Conductivity Detection Based On Phase-Sensitive Demodulation Principle

Wireless Sensing System-on-Chip for Near-Field Monitoring of Analog and Switch Quantities

An Improved Capacitively Coupled Contactless Conductivity Detection Sensor for Industrial Applications

Wireless Tiny Mass Sensor System Based On Fbar

Design and development of an ecg monitoring system based on wireless system-on-chip technology

Non-contact surface water conductivity measurement system

Design of the wireless system for health monitoring of a large span gymnasium structure

Capacitance-based wireless strain sensor development

A Contactless Battery Charging And Monitoring System For Wireless Sensor Network Nodes

NEW ON-LINE HIGH PRECISION tan δ MONITORING SYSTEM FOR CAPACITIVE EQUIPMENT

Development and Characterization of a Novel Interdigitated Capacitive Strain Sensor for Structural Health Monitoring

Fully self-powered instantaneous wireless liquid level sensor system based on triboelectric nanogenerator

Design of a Hydrostatic Liquid Level Wireless Transmitter for Efficient Level Measurement

Flexible contact and non-contact dual-mode capacitive sensor for sensing and assembling flexible, intelligent medical monitoring systems for wireless transmission of medical data

Dual-mode Sensor for Intelligent Solution Monitoring: Enhancing Sensitivity and Recognition Accuracy Through Capacitive and Triboelectric Sensing

A Wearable Capacitive Sensor Based on Ring/Disk‐Shaped Electrode and Porous Dielectric for Noncontact Healthcare Monitoring

Non-Contact Adaptive Voltage Sensor Based on Electric Field Coupling Principle

A Wireless Body Sound Sensor with a Dedicated Compact Chipset