Abstract:The drilling process is among the most crucial steps in exploration and production activities in the petroleum industry. It consists of using mechanical mechanisms to crush rocks by the drill bit to pass through the different geological layers. The drill-string continuously transforms the rotational movement from the top drive motor to the drill bit through the drill pipes. Due to the strong interactions with the rocks, aggressive vibrations can arise in the drill-string in its three dimensions, and consequently, this may create three types of synchronous vibrations: axial, lateral, and torsional. The severe status of the latter is known as the stick-slip phenomenon, and is the most common in rotary drilling systems. Based on field observations, it has been inferred that the high frequency stick-slip vibrations may lead to drill-string fatigues and even to premature rupture. In the best case, it reduces the drilling efficiency by decreasing the rate of penetration, due to which the drilling operations become proportionally expensive. The main novelties of this research work are the design of an H∞ observer-based controller to mitigate the high frequency stick-slip vibrations, and the quantitative analysis of the vibrations’ severity for ten degrees of freedom model. The observer is designed to estimate the non-measurable rotational velocity of the drill bit due to the severity of the vibrations, while the controller is dedicated to suppressing the vibrations by using the top drive inputs. Thus, many scenarios have been considered to test and analyze the observer performance and the controller robustness. Furthermore, a comparison with the LQG observer-based controller has been conducted, where H∞ has demonstrated better efficiency in suppressing the stick-slip vibrations under unstructured perturbations.

Sliding mode control of rotary drilling system with stick slip oscillation

Sliding Mode Control Design and Its Application to Hard Disk Drives

Mitigation of Stick-Slip Vibrations in Drilling Systems with Tuned Top Boundary Parameters

Control of a 3D Piezo-Actuating Table by Using an Adaptive Sliding-Mode Controller for a Drilling Process.

Backstepping sliding mode control of stabilized platform for fully rotary steerable drilling system based on nonlinear disturbance observer

Nonlinear motions of a flexible rotor with a drill bit: stick-slip and delay effects

Stick–Slip Vibration Characteristics Study of the Drill String Based on PID Controller

Observer-Based H∞ Controller Design for High Frequency Stick-Slip Vibrations Mitigation in Drill-String of Rotary Drilling Systems

Motion Simulation Analysis and Experimental Verification of Drill String Rotation Controller

Control of a slender rotary system subjected to dry friction and rub

Analysis on the dynamic characteristics of stick-slip vibration in deep well drill string system

Mechanism Analysis on Torsional Stick-slip Vibration of Drillstring in Extended Reach Well and Some Ways to Its Suppression

Coupled Axial-Torsional Dynamics in Rotary Drilling with State-Dependent Delay: Stability and Control

Observer-Based Adaptive Sliding Mode Compensation Position-Tracking Control for Drilling Tool Attitude Adjustment

Tool-face Control for Slide Drilling Based on Fuzzy Sliding Mode Controller

An Adaptive Toolface Control Method for Slide Steering Drilling

Sliding Mode Control for Underwater Multi-DoF Hydraulic Manipulator

Micro-Drilling Process Control by Using Adaptive Sliding Controller

Nonlinear Disturbance Observer Based Integral Sliding Mode Control for Tunnel Boring Machine.

Laboratory experiment of slide drilling tool-face control based on model similarity theory

Drilling Control System Using an Equivalent Input Disturbance-Based Control With a Neutral-Type Axial-Torsional Coupled Dynamics Model