Tool-face Control for Slide Drilling Based on Fuzzy Sliding Mode Controller

Kaixiang Li,Xiaoyu Zhong,Zaibin Cheng,Kaidong Chen,Qiuhai Lu,Jiaqi Chen

DOI: https://doi.org/10.1109/cac53003.2021.9727321

2021-01-01

Abstract:Slide drilling is widely used in the process of directional drilling, during which tool-face adjustment is almost completed by the driller and has not been controlled automatically yet. The main difficulty is to obtain an accurate dynamic model, due to a large amount of contact and friction between the drill string system and the wellbore. Therefore, in this paper, a fuzzy sliding mode control (FSMC) method that does not depend on the dynamic model is designed, and the selection criteria of the control parameters are proposed. The FSMC method only needs the tool-face angle as feedback and rotates the top drive angle in a limited control period by the top drive positioning, thus realizing the automatic adjustment of the tool-face. Then a small-scale experimental system is established to simulate the control process of tool-face angle. Finally, the FSMC method is used to control the tool-face on this experimental platform. The results prove that the FSMC method can automatically adjust the tool-face angle to the right position without overshooting and that the steady-state error is less than 10◦. The proposed method is expected to be applied in actual field drilling and achieves automatic control of tool-face, reducing the burden of drillers and improving work efficiency.