Abstract:In this paper, the synthesis of poly(3,4-ethylenedioxythiophene) (PEDOT) by cyclic voltammetry (CV) electrochemical deposition and its application in the counter electrode of solid-state dye-sensitized solar cells were studied. The influence of cycle times (10 similar to 50 times) on the morphology, thickness and optical properties of PEDOT films were explored by Fourier transform infrared spectroscopy (FTIR), atomic force microscope (AFM), scanning electron microscope (SEM) and ultraviolet-visible spectroscopy (UV-Vis). The photoelectrochemical properties of solid-state dye-sensitized solar cells based on PEDOT transparent counter electrode were characterized by J-V, electrochemical impedance spectroscopy (EIS), intensity modulated photocurrent spectrum/photovoltage spectrum (IMPSNS) and Tafel analysis. The results showed that an un-uniform film with the thickness of 0.5 mu m and light transmittance of 80% was formed when CV cycle times was 10, where the PEDOT film was not completely covered on the substrate. When the CV cycles reached 30 similar to 40, a uniform and dense transparent film was obtained and the highest photo-electric conversion efficiency of the corresponding solid-state dye-sensitized solar cells reached 5.34%. This is because uniform and dense surface, good optical properties and high photo- electric catalysis properties (J(0) =2.51 X 10(-3) A.cm(-2)) for I-3 in the electrolyte, made the device obtain larger diffusion coefficient (D-n=28.80 mu m(2).ms(-1)) and carrier diffusion length (L = 21 .41 mu m), which were favorable for charge transfer. When the number of CV cycles was further increased to 50 times, showing greater roughness, the PEDOT fihn was no longer growing uniformly. The PEDOT film deposited on the FTO surface underwent some dissolution and desorption, the PEDOT film became uneven, and the catalytic activity of PEDOT electrode to I-3(-) in electrolyte was reduced. The device with PEDOT transparent counter electrode fihn deposited by cyclic voltammetry could also achieve double-side illumination with good catalytic activity to the electrolyte. Under the condition of double-side illumination, the photoelectric performance of the device using electrodeposited PEDOT as transparent counter electrode was improved by about 20%. The improvement of the photoelectric performance of the device is mainly due to the increase in the absorption of photons by the double-sided illumination.

Photoelectric properties and thermal stability of PEDOT nanoparticles based on reversed micelle method

The characteristic properties of PEDOT nano-particle based on reversed micelle method

Preparation and Properties of Conducting Polymer Poly(3,4-ethylenedioxythiophene) Nanoparticles

Unravelling Doping Effects on Pedot at the Molecular Level: from Geometry to Thermoelectric Transport Properties

Conducting polymeric nanoparticles synthesized in reverse micelles and their gas sensitivity based on quartz crystal microbalance

In-situ doping and post-treatments modulate the photoelectrical properties and stability of electropolymerization poly(3,4-ethylenedioxythiophene)

Study on the Gas Sensitivity of PEDOT Nanoparticles Based on Reversed Micelle Method

Investigating the Mechanism of Post-Treatment on PEDOT:PSS Via Single-Particle Absorption Spectroscopy

The morphology and conductivity of PEDOT films under chemical synthesis

Progress in Synthesis of Conductive Polymer Poly(3,4-Ethylenedioxythiophene)

Nanoscale Electron Beam Patterning of PEDOT:PSS Free‐Standing Films for Enhanced Thermoelectric Performance

Photoelectric Properties of PEDOT Prepared Through a Modified LB Film Method

Electrochemical Synthesis of PEDOT and Its Application in Solid-State Dye-sensitized Solar Cells

A self-powered ultraviolet photodetector based on TiO 2 nanoarrays and poly(3,4-ethylenedioxyselenophene) with the enhanced performance by pyro-phototronic effect

Enhancing the Electrical Conductivity and Long-Term Stability of PEDOT:PSS Electrodes through Sequential Treatment with Nitric Acid and Cesium Chloride

The straightforward approach of tuning the photoluminescence and electrical properties of encapsulated PEDOT end-capped by pyrene

Rationalization of Microstructure Modulation and Doping on the Enhancement Mechanism of Thermoelectric Properties of PEDOT:PSS

Nanoengineering of poly(3,4-ethylenedioxythiophene) for boosting electrochemical applications

Unraveling the Order and Disorder in Poly(3,4-ethylenedioxythiophene)/Poly(styrenesulfonate) Nanofilms

Optical Spectra of p-Doped PEDOT Nano-Aggregates Provide Insight into the Material Disorder

In-situ Polymerization and Optical Properties of CdTe/PEDOT-PSS Microspheres