Abstract:A series of tungsten-gradually doped diamond-like carbon (DLC) films with functionally graded interlayer were prepared using a hybrid technique of vacuum cathodic arc/magnetron sputtering/ion beam deposition. With ‘compositionally graded coating’ concept, the deposition of wear-resistant carbon-based films with excellent adhesion to metallic substrate was realized. In the films, a functionally graded interlayer with layer sequence of Cr/CrN/CrNC/CrC/WC was first deposited onto the substrate, and then, a DLC layer doped with gradually decreasing content of W was coated on. The W concentration gradient along depth of the film was tailored by adjusting the W target current and deposition time. The characterized results indicate that the microstructural, mechanical and tribological properties of these films show a significant dependence on the W concentration gradient. A high fraction of W atom in carbon matrix can promote the formation of sp2 sites and WC1−x nanoparticles. Applying this coating concept, strongly adherent carbon films with critical load exceeding 100N in scratch test were obtained, and no fractures or delaminations were observed at the end of the scratched trace. The hardness was found to vary from 13.28 to 32.13GPa with increasing W concentration. These films also presented excellent tribological properties, especially significantly low wear rate under dry sliding condition against Si3N4 ball. The optimum wear performance with friction coefficient of 0.19 and wear rate of 8.36×10−7 mm3/Nm was achieved for the tungsten-gradually doped DLC film with a graded W concentration ranging from 52.5% to 17.8%. This compositionally graded coating system might be a potentially promising candidate for wear-resistant carbon-based films in the demanding tribological applications.

Influence of Cr Contents and Nanograin Sizes on Microstructure, Mechanical and Sliding Tribological Behaviors of Hard Cr-Diamond-Like Carbon Films

Influence of Ag Content and Nanograin Size on Microstructure, Mechanical and Sliding Tribological Behaviors of Ag-DLC Films.

Diamond-like Carbon Film on 20 CrNiMo Steel Prepared by Hollow-Cathode Glow Discharge

Tribological Properties of DLC Coatings with Varying Cr Concentration in Water Lubrication

Micro/Nanomechanical and Tribological Properties of Thin Diamond-Like Carbon Coatings

Microstructure and Tribological Properties of Diamond-Like Carbon and Tialsicn Nanocomposite Coatings

Influence of Copper Content and Nanograin Size on Toughness of Copper Containing Diamond-Like Carbon Films

Microstructural, Mechanical and Tribological Properties of Tungsten-Gradually Doped Diamond-Like Carbon Films with Functionally Graded Interlayers

Improvement of Tribological Behaviour of Biomedical Nanocrystalline Titanium by Magnetron Sputtered DLC/SiC Double Layer Films

Role of carbide content in governing the mechanical and tribological properties of DLC/Cr 3 C 2 –NiCr duplex coatings

Tribological Performance of Metal Doped Diamond-like Carbon Films Deposited on CoCrMo Alloy

Microstructural evolution and tribology of Mo-doped diamond like carbon nanocomposite film

Microstructure and Mechanical Properties of Dlc Films Doped with High Crystallinity Crn Nanoparticles

A Study of Hard Diamond-Like Carbon Films in Mid-Frequency Dual-Magnetron Sputtering

Electrodeposition, microstructure and tribological performance of Ni/(N) incorporated diamond-like carbon films

The effects of Cr and B doping on the mechanical properties and tribological behavior of multi-layered hydrogenated diamond-like carbon films

Microstructure and water-lubricated friction and wear properties of CrN(C) coatings with different carbon contents

Composition, Structure and Properties of CrAlN-DLC Hard Composite Films Deposited by Arc Ion Plating

Mechanical and Tribological Properties of Diamond-Like Carbon Films Deposited by Electron Cyclotron Resonance Microwave Plasma Chemical Vapor Deposition

Growth and Tribological Property Characterization of Diamond-Like-Carbon Films

Role of Carbide Content in Governing the Mechanical and Tribological Properties of DLC/Cr3C2–NiCr Duplex Coatings