Abstract:A series of tungsten-gradually doped diamond-like carbon (DLC) films with functionally graded interlayer were prepared using a hybrid technique of vacuum cathodic arc/magnetron sputtering/ion beam deposition. With ‘compositionally graded coating’ concept, the deposition of wear-resistant carbon-based films with excellent adhesion to metallic substrate was realized. In the films, a functionally graded interlayer with layer sequence of Cr/CrN/CrNC/CrC/WC was first deposited onto the substrate, and then, a DLC layer doped with gradually decreasing content of W was coated on. The W concentration gradient along depth of the film was tailored by adjusting the W target current and deposition time. The characterized results indicate that the microstructural, mechanical and tribological properties of these films show a significant dependence on the W concentration gradient. A high fraction of W atom in carbon matrix can promote the formation of sp2 sites and WC1−x nanoparticles. Applying this coating concept, strongly adherent carbon films with critical load exceeding 100N in scratch test were obtained, and no fractures or delaminations were observed at the end of the scratched trace. The hardness was found to vary from 13.28 to 32.13GPa with increasing W concentration. These films also presented excellent tribological properties, especially significantly low wear rate under dry sliding condition against Si3N4 ball. The optimum wear performance with friction coefficient of 0.19 and wear rate of 8.36×10−7 mm3/Nm was achieved for the tungsten-gradually doped DLC film with a graded W concentration ranging from 52.5% to 17.8%. This compositionally graded coating system might be a potentially promising candidate for wear-resistant carbon-based films in the demanding tribological applications.

Micro/Nanomechanical and Tribological Properties of Thin Diamond-Like Carbon Coatings

Diamond-like Carbon Film on 20 CrNiMo Steel Prepared by Hollow-Cathode Glow Discharge

Nanoindentation and nanoscratch behaviors of DLC coatings on different steel substrates

Mechanical and Tribological Properties of Diamond-Like Carbon Films Deposited by Electron Cyclotron Resonance Microwave Plasma Chemical Vapor Deposition

Nano-tribology Study of Ultrathin Diamond-like Carbon (DLC)

Wear-resistance of Diamond-like Carbon Thin Films Deposited on the Metal Seal Ring Surface by Plasma Gun at an Atmospheric Pressure

Microstructure and Tribological Properties of Diamond-Like Carbon and Tialsicn Nanocomposite Coatings

Growth and Tribological Property Characterization of Diamond-Like-Carbon Films

Tribological Properties of Diamond-Like Carbon Films Deposited by Pulsed Laser Arc Deposition

Tribological Properties of Diamond– Like Carbon Films Deposited by PECVD

Structural Characters and Tribological Properties of Diamondlike Carbon Films

Nano-scratch and Fretting Wear Study of DLC Coatings for Biomedical Application

A study of the wear mechanism of diamond-like carbon films

Influence of Cr Contents and Nanograin Sizes on Microstructure, Mechanical and Sliding Tribological Behaviors of Hard Cr-Diamond-Like Carbon Films

Mechanical and Unlubricated Tribological Properties of Titanium-Containing Diamond-Like Carbon Coatings

Tribological Behavior and Mechanism of Diamond-like Carbon Films

Effects of sp3 bond ratio and modulation ratios on nanotribology behaviors of diamond-like carbon coatings investigated using atomistic nanoscratching simulations

Tribological Performance of Ultrathin Diamond-Like Carbon Films Prepared by Plasma-Based Ion Implantation

Microstructural, Mechanical and Tribological Properties of Tungsten-Gradually Doped Diamond-Like Carbon Films with Functionally Graded Interlayers

Viscoplastic Properties and Tribological Behavior of Diamond-Like Carbon Films Using Nanoindentation and Nanoscratch Tests

Investigation of the Mechanical and Tribological Properties of Diamond-Like Carbon Films on YG8 and High-Speed Steel Substrates with W Buffer Layers