Study on Cutting Force Coefficients in End Milling Die Steel 4Cr16mo

LIU Min,JING Lu-lu,AN Qing-long,CHEN Ming

DOI: https://doi.org/10.3321/j.issn:1006-2467.2009.01.006

2009-01-01

Abstract:Based on the dynamic milling and orthogonal experiments in end milling die steel 4Cr16Mo,this paper discussed the different influence made by four input cutting parameters(cutting speed,feed rate,radial and axial depth) on the tangential and radial cutting force coefficients and then analyzed how to choose optimal parameters in processing.The analysis results shows that the radial depth of cut has the largest effect on tangential cutting force coefficient,followed by cutting speed,then axial depth of cut and feed per tooth,while feed per tooth has the largest effect on radial cutting force coefficient,followed by the radial depth of cut,then the axial depth of cut and cutting speed.It is found in the further experiment that the prediction value of the two coefficients using both quadratic polynomial model and partial least-square regression can fairly match the practical case which will be beneficial to the production.