Abstract:Improving the dynamic regulation ability of thermal power units is effective for realizing flexible scheduling in modern power systems. At present, the unit regulation capacity is usually reflected by the load adjustment of the main steam pressure and flow tracking ability, through the calculation of the given and real-time deviation to complete the load, and by pressure adjustment. However, although the calculation involved in this method is easy and the results are intuitive, overshoot and lag can easily occur. The main reason for this is that the process from boiler combustion to turbine works has strong hysteresis and inertia, and the feedback signal of the pressure and flow rate cannot dynamically reflect the change in boiler combustion and steam energy. According to the heat transfer process of the unit, the main steam temperature can directly reflect the energy transfer in the furnace combustion process and then reflect the changing trend of steam energy. Analyzing the changing characteristics of the temperature, pressure, and flow of superheated steam under rapid load regulations makes it possible to calculate the instantaneous energy storage value of the main steam before the regulating valve, and this value was inserted into the coordinate system as a new feedforward signal. Finally, a simulation model was established by using the actual running data of the unit. A simulation experiment under variable working conditions demonstrated that this method could improve the dynamic adjustment of the unit to load and pressure and help the power grid absorb renewable energy.

The Thermal Economic Evaluation for Sliding Pressure Operation in 330MW Steam Turbine

Optimization of Gliding Pressure Operation of Steam Turbine Sets

Steam Turbine Sliding Pressure Curve Colligation Optimization based on Real-time Correction Using Back Pressure

Optimization of Start-up Process in Combined Cycle Steam Turbine of a Power Plant

Pressure pulsation analysis of runner and draft tube of pump turbine under different working conditions

A Variable Condition Calculation Method for Thermal Power Units Sliding Pressure Operation

Optimization Tests on Main Steam Pressure for 600-MW Air-Cooling Heat Supply Units

Economic analysis of peak-shaving sliding pressure operation of 300 MW unit in Shajiao A Power Station

Economic Analysis of a 660MW Supercritical Turbine for Steam Initial Parameters

Sliding Pressure Operation of Gas-steam Combined Cycle Heat Recovery Boiler

Determination of the Optimum Initial Operation Pressure of a Steam Turbine Unit Based on a BP(Back Propagation) Neural Network and SA-BBO(Simulated Annealing Biogeography-based Optimization) Algorithm

STUDY ON THERMODYNAMIC PROPERTIES OF NON-REHEAT 200 MW DOUBLE-EXTRACTION STEAM TURBINE UNITS

Economic Analysis of Peak Shaving Sliding Pressure Operation of 660MW Unit

Analysis of High Back Pressure Heat Supply Efifciency in High-temperature Steam-turbine Units

Impact of Steam-Equalizing Equipment on Exhaust Steam Pressure of 300 MW Steam Turbine and Economic Analysis

Application Study on Low Vacuum Circulating Water Heat Supply of a 50 MW Turbine

Lower-Pressure Cylinder Exhaust Steam Channel Optimization of 630 MW Steam Turbine

An Optimization Method of Steam Turbine Load Resilient Adjustment by Characterizing Dynamic Changes in Superheated Steam Energy

Analysis of the Operational Behavior of a 600MW Steam Turbine Set's Main Stop and Governing Valve System

Economic Analysis and Operation Simulation of Low Pressure Economizer System in 135 Mw Thermal Power Plant

Thermoeconomic Optimization of Steam Pressure of Heat Recovery Steam Generator in Combined Cycle Gas Turbine under Different Operation Strategies