Abstract:There are heat transfer correlations for heat transfer analysis in single tube geometries after several experimental and theoretical heat transfer studies in these single tube geometries. This is not the case for heat transfer analysis in rod bundle geometry with regard to proposed square fuel assembly of the Supercritical-Water-Cooled Reactor (SCWR) European Atomic Energy (EURATOM) design. Thus limited heat transfer studies exist on rod bundle geometry at supercritical pressures. Heat transfer correlations with accurate prediction capabilities of coolant and wall temperatures will be helpful in carrying out heat transfer studies at supercritical pressures. This paper presents the performance of twelve selected heat transfer correlations assessed on the 1/8th bare square fuel assembly of the SCWR EURATOM design using Simulation of Turbulent flow in Arbitrary Regions Computational Continuum Mechanics C ++ based code (STAR-CCM + CFD code). The obtained numerical results were compared with the results obtained by Waata numerical experimentation. Overall, the Cheng et al. correlation provided the most satisfying prediction for the wall temperatures in all the sub-channels and captured closely Wataa's Numerical data. The maximum wall temperature was obtained in sub-channel 9, the hottest sub-channel and exceeded the design limit 620 °C by 60 °C for the Cheng correlation. The difference in temperature between the hottest and coldest sub-channels 9 and 1 respectively was approximately 80 °C. It was found that Cheng correlation is best suited for heat transfer prediction in rod bundle geometry at supercritical pressures with regard to the proposed square fuel assembly of the SCWR EURATOM design. It was also found that the different numerical tools adopted for this study and Waata study were able to capture the trends of normal, enhanced and deteriorated heat transfer regimes normally observed at supercritical pressures. Nevertheless, experimental investigations involving rod bundles adopted in this study should be conducted to validate the results obtained numerically and address the inconsistency of the conclusions drawn when compared with Waata data and other similar studies.

Optimisation of CANFLEX-SCWR bundle through subchannel analysis

SCWR subchannel code ATHAS development and CANDU-SCWR analysis

Subchannel analysis of CANDU-SCWR fuel

Coupled Neutronics/Thermal-Hydraulics Analysis of PT–SCWR with 54-Element Bundle Design

Coupled neutronics/thermal–hydraulics analysis of CANDU–SCWR fuel channel

Optimization of 54-Element Pressure Tube SCWR Bundle Through Neutronics/thermalhydraulics Coupling Analysis

Development of sub-channel analysis code for CANDU-SCWR

Improvement and Validation of a Sub‐channel Analysis Code for a Lead‐cooled Reactor with Wire Spacers

Development of a Subchannel Analysis Code for SFR Wire-Wrapped Fuel Assemblies

Sub-channel Analysis of CANDU–SCWR and Review of Heat-Transfer Correlations

Sub-Channel Analysis Of Scwr Assembly With Double-Row Rods

Subchannel Analysis of Wire Wrapped Scwr Assembly

Multi-scale Thermal-Hydraulics Analysis on SCWR Fuel Qualification Test Loop

Thermal Consideration of CANDU-SCWR Sliding Pressure Startup Through Subchannel Analysis

Coupled analysis and improvements for Canadian-SCWR core design

Core and Sub-Channel Evaluation of A Thermal Scwr

Thermal Hydraulic Review of Light Water Reactor Based on Subchannel Code CTF

Sub-Channel/System Coupled Code Development and Its Application to Scwr-Fqt Loop

Assessment of heat transfer correlations in the sub-channels of proposed rod bundle geometry for supercritical water reactor

Thermal-hydraulic analysis of flow blockage in a supercritical water-cooled fuel bundle with sub-channel code

Core Design Study on CANDU-SCWR with 3D Neutronics/thermal-Hydraulics Coupling