Abstract:Compared with the position sensor control, sensorless control avoids a lot of defects caused by the position sensor, at the same time makes the system more stability and stronger anti-interference performance, it has more advantages and meets control field's requirements better in the future, it has gradually become a hotspot in the brushless DC motor control field. The rotor position detection has been a very critical research in the brushless DC motor sensorless control. In this paper, a new type of rotor position detection method is proposed, which is based on the principle and mathematical model of a brushless DC motor after the analysis of advantages and disadvantages of the back EMF principle of zero-detection and the method of the back-EMF superposition, which means a combination of the method of the two rotor position detection, as above. This method neither need a delay of 30° nor require a depth filter, the hardware circuit is also simple and there is no need to compensate for the phase shift. Then, the frequency of the detection signal is three times of fundamental wave frequency in this method and the detection signal is easier to detect when the motor running at low speed, which expand the applicable speed range of the electric motor. This paper analyzes the principle and commutation logic of the rotor position detection method, it come up with a conclusion that the stagnation point of the three BEMF superposition derivative is the commutation points of the stator windings, and it uses the method of the back-EMF zero crossings to determine the current conduction state. The simulation model of the brushless DC motor's control system is established in MATLAB /Simulink it uses speed and current double close loop PI control. The result shows that the method is correct and feasible, it can get the right rotor position signal and control motor commutation correctly, the method can achieve the control of brushless DC motor without position sensor, and it can provide a reference for further research.

Position Sensor of Axial and Radial Air Gap Hybrid Magnet Circuit Multi-Coupling Motor

Analyze the Position Sensor and the Axial Exciting Coil EMF of Axial and Radial Air Gap Hybrid Magnet Circuit Multi-Coupling Motor

Analysis the electromagnetic torque and magnetic field of the axial and radial air gap hybrid magnet circuit multi-coupling motor

Position Sensorless Control Based on Sliding Mode Observer for Multiphase Bearingless Motor with Single Set of Windings

ONLINEAR MODEL AND QUANTITATIVE ANALYSIS OF PERFORMANCE PARAMETER FOR THE AXIAL AND RADIAL AIR GAP HYBRID MAGNET CIRCUIT MULTI-COUPLING MOTOR

Sensorless Control Strategy of Novel Axially Magnetized Vernier Permanent-Magnet Machine

A Novel Rotor Position Detection Method for Sensorless Control of Magnetic-Geared Permanent-Magnet Brushless Motor

Rotor Position Estimation Strategy for Self-Sensing Active Magnetic Bearing Considering Eddy Currents

Radial Position Detection Of Five-Phase Bearingless Pm Motor

An Improved Rotor Position Estimation Method for PMSM Using Low-Resolution Hall-Effect Sensors

Theoretical and Experimental Research on Hybridmagnetic-Circuit Multi-Couple Motor

Sensorless Position Estimation for Permanent Magnet Synchronous Linear Motor with Variable Coupling Length

Principle and simulation of a 5-phase bearingless permanent magnet-type synchronous motor

Axial Active-Passive Suspension Electromagnetic System in Radial Air Gap for the Maglev Pump.

Analyses and Compensation of Rotor Position Detection Error in Sensorless Pm Brushless Dc Motor Drives

Sensorless Operation Of An Inset Pm Bearingless Motor Implemented By The Combination Approach Of Mras And Hf Signal Injectionac

Rotor Position Detection Based on Magnetically Coupled Resonant Principle and Its Implementation

Position and radial displacement sensorless control method for bearingless switched reluctance motors

A Hall Sensor-Based Position Measurement with On-Line Model Parameters Computation for Permanent Magnet Synchronous Linear Motor

Rotor position detection based on BEMF zero-crossing detection method with three-EMF force superposition

Direct Rotor Position Detection Method for Sensorless Brushless DC Motors