Abstract:Capacity and voltage fading of lithium-and-manganese-rich (LMR) cathodes is a major challenge for the application of this category of material, which is believed to be associated with the structural and chemical evolution of the materials.[1-3] As one of the most promising cathode materials for next generation lithium ion batteries, LMR cathode materials have the expression xLiMO2·(1-x)[Li2MnO3] (M=Mn, Ni, Co, 0≤x<1). As the parent component of LMR, Li2MnO3 cathode materials also attracted much attention for many reasons. First, Li2MnO3 itself has a very high theoretical capacity. Second, it can enhance our fundamental understanding of the electrochemistry of Mn-containing cathode materials. Thirdly, we can obtain the knowledge necessary for design new LMR cathode materials. Li2MnO3 cathode was initially believed electrochemical inert because all the Mn cations are Mn in this material until Kalyani et al. demonstrated that Li2MnO3 could be electrochemically activated in 1999.[4] It has been claimed that prolonged cycling could transform Li2MnO3 to LiMn2O4-spinel.[5, 6] However, recently X-ray absorption spectroscopy results from cycled sample are not consistent with the LiMn2O4-spinel structure, instead the P3 structure was proposed.[7] In a chemically delithiated Li2MnO3 sample, Wang et al. observed the formation of MnO2 phase.[8] Up to now, it is still not clear which structure is formed after charge-discharge cycles and how the structure evolves during the cycling of Li2MnO3 cathode. In this work, we report the detailed structural and chemical evolutions of Li2MnO3 cathode captured by using aberration corrected scanning/transmission electron microscope (S/TEM) after certain numbers of charge-discharge cycling of the batteries. It is found that structural degradation occurs from the very first cycle and is spatially initiated from the surface of the particle and propagates towards the inner bulk as cyclic number increase, featuring the formation of the surface phase transformation layer and gradual thickening of this layer. The structure degradation is found to follow a sequential phase transformation: monoclinic C2/m → tetragonal I41 → cubic spinel (as shown in Figure 1), which is consistently supported by the decreasing lattice formation energy based on DFT calculations. For the first time, high spatial resolution quantitative chemical analysis reveals that 20% oxygen in the surface phase transformation layer is removed and such newly developed surface layer is a Li-depleted layer with reduced Mn cations (Figure 2). This work demonstrates a direct correlation between structural degradation and cell’s electrochemical degradation. In a more general term, since Li2MnO3 cathode is the parent compound for LMR cathode, this work will enhance our understanding on the degradation mechanism of LMR cathode materials during cycling.

Structure Change of Orthorhombic LiMnO2cathodes During Electrochemical Cycle for Rechargeable Lithium Battery

Phase Transformations And Activation Characteristics Of Layered Orthorhombic Limno2 During Electrochemical Cycling

Evolutions of Phase and Microstructure of Orthorhombic Li1-xMnO2 (0 <= x <= 0.95) during the First Charge Process

Transformation from monoclinic LiMnO2 to spinel Li xMn2O4 during electrochemical cycling

Evolution Mechanism of Phase Transformation of Li-rich Cathode Materials in Cycling

Charge-Discharge Cycling Induced Structural and Chemical Evolution of Li2MnO3 Cathode for Li-ion Batteries

Electrochemical Behavior And Surface Structural Change Of Limn2o4 Charged To 5.1 V

Structural and Chemical Evolution of Li- and Mn-Rich Layered Cathode Material

Synthesis and Structure Transformation of Orthorhombic Limno2 Cathode Materials by Sol-Gel Method

The phase-change evolution from surface to bulk of MnO anodes upon cycling

Unusual Spinel-to-Layered Transformation in LiMn 2 O 4 Cathode Explained by Electrochemical and Thermal Stability Investigation.

Reactions of the Li2MnO3 Cathode in an All-Solid-State Thin-Film Battery during Cycling

Structural Transformations in Li2mnsio4: Evidence That A Li Intercalation Material Can Reversibly Cycle Through A Disordered Phase

Probing Reversible Multielectron Transfer and Structure Evolution of Li1.2Cr0.4Mn0.4O2 Cathode Material for Li-Ion Batteries in a Voltage Range of 1.0–4.8 V

Surface Structure Evolution of LiMn2O4 Cathode Material Upon Charge/Discharge

Structure Change of Li1.05Ni0.05Mn1.9O4 Cathode Material During Li Extraction

Structure and electrochemical performance of spinel LiMn2O4 synthesized by mechanochemical process

Insight into the cation migration and surface structural evolution of spinel LiNi0.5Mn1.5O4 cathode material for lithium-ion batteries

Evolution of Lattice Structure and Chemical Composition of the Surface Reconstruction Layer in Li1.2ni0.2mn0.6o2 Cathode Material for Lithium Ion Batteries

Formation of the Spinel Phase in the Layered Composite Cathode Used in Li-Ion Batteries

Structural Stability and Electrochemical Phase Transition of LiMnO2 Compounds As Cathode Materials for Li-ion Batteries