Abstract:Lithium-rich layered oxides have attracted much attention due to their high discharge capacity (>250 mA h·g–1). However, lithium-rich layered cathodes suffer from poor rate capabilities and voltage decay, which seriously limit their practical application. Herein, a unique @spinel double-spinel shell heterostructure is designed and successfully synthesized via coprecipitation and high-temperature solid-phase methods. In particular, lithium-rich layered oxides show good rate capabilities and high capacity retention when the molar amount of cobalt acetate and manganese acetate is 5%. After 100 cycles at 0.2 C, a discharge capacity of 232 mA h g–1 and a capacity retention of 92.7% can be obtained. The superior electrochemical performance of the in situ-transformed Li-rich layered cathode can be attributed to the unique three-dimensional diffusion channels for Li ions of the surface spinel phase. Besides, the in situ-transformed LiCoMnO4 shell can also improve the structural stability of the Li-rich layered oxides by reducing the side reactions and protecting the material from being corroded by the electrolyte. This study provides a strategy for surface modification, which can effectively improve the electrochemical performance of Li-rich layered cathode materials with high performance.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.1c01955.SEM image of the precursor Ni1/6Co1/6Mn4/6CO3 and the corresponding mapping spectrum; ex situ XRD spectra of the LLO and LSS-0.05 samples; EDS line scan of the selected area and the corresponding HTEM diagram of the LSS-0.05 sample; CV and dQ/dV curves of the first three cycles of the LLO, LSS-0.05, and LSS-0.1 samples; initial charge and discharge curves of LiCoMnO4, LSS-0.2, and LSS-0.4 samples; discharge curves of LLO, LSS-0.05, and LSS-0.1 samples at different rates and with different cycles; typical single titration curve of GITT measurements; equivalent circuit of half-cells; and EIS spectra of LLO, LSS-0.05, and LSS-0.1 samples in the initial cycle (PDF)This article has not yet been cited by other publications.

Phase Transformations And Activation Characteristics Of Layered Orthorhombic Limno2 During Electrochemical Cycling

Evolutions of Phase and Microstructure of Orthorhombic Li1-xMnO2 (0 <= x <= 0.95) during the First Charge Process

Structure Change of Orthorhombic LiMnO2cathodes During Electrochemical Cycle for Rechargeable Lithium Battery

Preparation, Microstructure And Electrochemical Properties Of Spherical-Like Orthorhombic Limno2

Hydrothermal Synthesis of Layer LiMnO2

Synthesis and Structure Transformation of Orthorhombic Limno2 Cathode Materials by Sol-Gel Method

Revealing Lithium Configuration in Aged Layered Oxides for Effective Regeneration

Long-Term Cycle Stability Enabled by the Incorporation of Ni into Li2MnO3 Phase in the Mn-Based Li-Rich Layered Materials

Unusual Spinel-to-Layered Transformation in LiMn 2 O 4 Cathode Explained by Electrochemical and Thermal Stability Investigation.

Structural Stability and Electrochemical Phase Transition of LiMnO2 Compounds As Cathode Materials for Li-ion Batteries

Topotactic Phase Transformation of Lithiated Spinel to Layered LiMn0.5Ni0.5O2: The Interaction of 3-D and 2-D Li-ion Diffusion

Electrochemical Performance and in Situ Phase Transition Analysis of Iron-Doped Lithium Manganese Phosphate

Synthesis and Performance of LiMnO 2 As Cathodes for Li-ion Batteries

Exploit Li 2 MnO 3 activity by two phase coexistence at atomic level towards high performance Mn-based Co-free Li-rich cathodes

Investigation on the Electrochemical Activation Process of Li1.20Ni0.32Co0.004Mn0.476O2

Insight into the Synergistic Effect Mechanism Between the Li2MO3 Phase and the LiMO2 Phase (M = Ni, Co, and Mn) in Li- and Mn-rich Layered Oxide Cathode Materials

In Situ Induced Lattice‐Matched Interfacial Oxygen‐Passivation‐Layer Endowing Li‐Rich and Mn‐Based Cathodes with Ultralong Life

Enhanced long-term cyclability in Li-Rich layered oxides by electrochemically constructing a LixTM3-xO4-type spinel shell

Mechanisms and applications of layer/spinel phase transition in Li- and Mn-rich cathodes for lithium-ion batteries

The Effects of Surface Polyanions on the Lithium-Excess Layered Cathode

Improving the Electrochemical Performance of a Lithium-Rich Layered Cathode with an In Situ Transformed Layered@Spinel@Spinel Heterostructure