Abstract:Relighting of jet engines at high altitudes is very difficult because of the high velocity, low pressure, and low temperature of the inlet airflow. Successful ignition needs sufficient ignition energy to generate a spark kernel to induce a so-called critical flame initiation radius. However, at high altitudes with high-speed inlet airflow, the critical flame initiation radius becomes larger; therefore, traditional ignition technologies such as a semiconductor igniter（SI） become infeasible for use in high-altitude relighting of jet engines. In this study, to generate a large spark kernel to achieve successful ignition with high-speed inlet airflow, a new type of multichannel plasma igniter（MCPI） is proposed. Experiments on the electrical characteristics of the MCPI and SI were conducted under normal and sub-atmospheric pressures（P = 10–100 kPa）. Ignition experiments for the MCPI and SI with a kerosene/air mixture in a triple-swirler combustor under different velocities of inlet airflow（60–110 m/s）, with a temperature of 473 K at standard atmospheric pressure, were investigated. Results show that the MCPI generates much more arc discharge energy than the SI under a constant pressure; for example, the MCPI generated 6.93% and 16.05% more arc discharge energy than that of the SI at 30 kPa and 50 kPa, respectively. Compared to the SI, the MCPI generates a larger area and height of plasma heating zone, and induces a much larger initial spark kernel.Furthermore, the lean ignition limit of the MCPI and SI decreases with an increase in the velocity of the inlet airflow, and the maximum velocity of inlet airflow where the SI and MCPI can achieve successful and reliable ignition is 88.7 m/s and 102.2 m/s, respectively. Therefore, the MCPI has the advantage of achieving successful ignition with high-speed inlet airflow and extends the average ignition speed boundary of the kerosene/air mixture by 15.2%.

A test study of underwater ignition of solid rocket motor

Numerical study on ignition start-up process of an underwater solid rocket motor across a wide depth range

A Thrust Test Method for Water Ramjet Engine

Research on the Safety of Long Term Storage Solid Rocket Motor with Debonded Layer

Numerical Study of Supersonic Jet Characteristics of Underwater Solid Rocket Engine

Study on Numerical Simulation of Underwater Launch for End-Burning Grain Solid Motor with Embedded Wire

Experimental Study on the Ignition in a Scramjet with a Self-Designed Water Plasma Ignitor

Experimental Investigation on Electrical Characteristics and Ignition Performance of Multichannel Plasma Igniter

Trajectory Simulation for Underwater Vehicle with Power-Lunched

Experimental Research on Ignition Process of a Supersonic Combustor Based on a Strut Fueled with Liquid Kerosene

Numerical Modeling and Studies of Ignition Transients in End-Burning-Grain Solid Rocket Motors

The Research on High-Speed Gas Jet of Rocket Nozzle Underwater

Numerical Study of High-Energy Spark Ignition Characteristics in a Scramjet Combustor

Numerical Investigation on the Mechanism of Solid Rocket Motor Instability Induced by Differences between On-Ground and In-Flight Conditions

Experimental and Numerical Investigations on the Ignition of RBCC Gas-Oxygen/Kerosene Rocket Ejector

Research on the vertical launching of direct igniting underwater missile

A Novel Way to Enhance the Spark Plasma-Assisted Ignition for an Aero-Engine under Low Pressure

Experimental Investigation on High-Altitude Ignition and Ignition Enhancement by Multi-Channel Plasma Igniter

Ignition and Flame Stabilization of a Strut-Jet RBCC Combustor with Small Rocket Exhaust.

Numerical Research on the Underwater Igniting Process of Submarine-Based Missile

Numerical simulation of the effect of multiple factors on the ignition process of a solid rocket motor