Abstract:The aims of this study are to determine the behaviors of regression rate and thrust regulation of a combined solid rocket motor, which is capable of achieving energy management. A numerical model was developed to capture the regression rate and simulate the combustion process of combined solid rocket motor by combining the Navies-Stokes equations with turbulence and gas-solid coupling models. The numerical method employs a 24-step reaction mechanism to characterize the combustion of aluminum and oxidizing gases with an eddy-dissipation-concept model. The regression rates of both grain strand and solid-fuel burning in subsonic condition were obtained, which show good agreements with the experimental data, validating the proposed model. Thereafter, the flow field structure was firstly illustrated to understand the evolution of the combustion process. The recirculation zones are formed behind the back-facing steps and thus enhance the diffusing of oxidizer towards the burning surface, sustaining the burning of solid-fuel via heat feedback. Secondly, a parametric study presents that the regression rate and surface temperature of solid grain increase with increasing oxidizer mass flow rate and reduce with increasing inner diameter of gain hole; and formulas are obtained to predict the regression rates for combined solid rocket motor with different oxidizer mass flow fluxes. Finally, it is shown that the present combined solid rocket motor can obtain relatively high combustion efficiency for all cases studied, and the regulation ratio of thrust exceeds the corresponding variation ratio of oxidizer mass flow rate. The present study not only elaborates the regression rate and thrust behaviors of combined solid rocket motor but also provides a guideline for energy management of solid rocket motor.

Study on Numerical Simulation of Underwater Launch for End-Burning Grain Solid Motor with Embedded Wire

Numerical Study for End-Burning Solid Motor Embedded with Wire

Numerical study on ignition start-up process of an underwater solid rocket motor across a wide depth range

A Thrust Test Method for Water Ramjet Engine

Numerical Research on the Underwater Igniting Process of Submarine-Based Missile

Numerical Modeling and Studies of Ignition Transients in End-Burning-Grain Solid Rocket Motors

Numerical Research on Thrust Peak for Missile Launching Underwater

Numerical study of the hydrodynamic performances of surface piercing propeller

Numerical Study of Supersonic Jet Characteristics of Underwater Solid Rocket Engine

Numerical Research for Adjusting Thrust of Solid Rocket Motor by Using the Embedded-wire Grain

Numerical Simulation of Underwater Supersonic Jet of Vehicle with Shell-Shaped Flow Control Structure

Numerical Simulation on Hydrodynamic Characteristics of Submarine Missile in the Vertical Launch Process

Numerical Simulation on Field Characteristics of the Horizontal Gas Jet Flow of Underwater Vehicle

Numerical analysis for two-phase flow in dual-thrust chamber with finocyl grain

Influence of Outline of Missile Tail on the Thrust of Solid Motor Launching under Water

A test study of underwater ignition of solid rocket motor

Numerical investigation on regression rate and thrust regulation behaviors of a combined solid rocket motor with aluminum-based fuel

Numerical Simulation of the Launching of Underwater Vehicle

Numerical Simulation of the Fluid Flows Around a Missile with Thrust-Vectoring Control System Launched Underwater

Tuning the Ballistic Performance of a Single-Burning-Rate Grain Solid Rocket Motor via New Discontinuous Embedded Metal Wires

Numerical Study on Performance of Bubbly Water Ramjet Engine