Abstract:Due to the advantages of low cost, easy fabrication, mechanical flexibility, the research on organic solar cells has attracted a lot of attentions in the last decades. Among countless organic materials, the most successful ones are conjugated polymers, which were widely used in bulk heterojunction (BHJ) in conjugation with the fullerene [1]. In view of the fact the interpenetratedphase-separated p-n composites offer more chances for excitons to reach the p-n interfaces, BHJ greatly facilitates the dissociation of photogenerated excitons before decaying to ground state. During exciton dissociation process, the exciton delocalization at an ultra fast timescale has been observed recently, which has considerable effects on the charge generation and device performance. In this work, based on the recent studies [2–4], we established a theoretical model of polymer solar cells (PSCs) incorporating the exciton delocalization process. Through the model, we found the increase of delocalized excitons (compared to the total generated excitons) will significantly improve the short-circuit current, open-circuit voltage, fill factor and power conversion efficiency of PSCs. Particularly, the saturations of fill factor and open-circuit voltage are also observed, and the saturation points depend on the active layer thickness and recombination rate. For instance,the device model of 200nm thickness active layer has the saturated fill factor at 70% delocalization ratio, which is close to the conventional ratio of practical devices. The device configuration studied comprises a BHJ active layer sandwiched between a transparent anode and a metal cathode. Moreover, the active material is a mixture of OC 1 C 10 -PPV, as the donor, and PCBM, as the acceptor [5]. The generation rate of excitons is assumed to be homogeneous. The model proposed involves both the drift-diffusion model for photocarriers (Eq. (1)) and the diffusion and dissociation model for excitons (Eq. (2)). The governing equations are given as follows equation where q is elementary charge, n(p) is the electron (hole) density, and r G , r R are the parametersfor controlling exciton generation and bulk recombination, respectively. E is the internal E-field. µ and D are the mobility and diffusion coefficients. The exciton density is denoted by X diff and k diss is the exciton dissociation rate. The recombination R is taken to be a bimolecular form,with the rate given by Langevin [6], and η s is 0.25 for the singlet excitons. Using the physical parameters given by experiments [5], the nonlinear governing equation sets are solved self-consistently. The excitons are delocalized at an ultra fast timescale to form electron-hole pairs, which is much faster than the photo carrier relaxation time and exciton diffusion time. Consequently, the delocalization process was simulated by directly inserting the delocalization ratio η del into the equations.

Influence of optical interference and carrier lifetime on the short circuit current density of organic bulk heterojunction solar cells

The Role Of Exciton Delocalization In The Performance Of Bulk-Heterojunction Polymer Solar Cells

Analysis of the Effect of Active Layer Thickness on Polymer Solar Cell Performance Based on Optical and Opto-Electronic Model

A Comprehensive Multiphysics Model for Organic Photovoltaics

Simulating exciton delocalization in organic solar cells by a modified drift-diffusion model

Effects of Organic/Organic Interface on Recombination Efficiency in Double-Layer Organic Diodes

Analytic model for organic bulk heterojunction solar cells based on Saha equation for exciton dissociation

Exciton delocalization incorporated drift-diffusion model for bulk-heterojunction organic solar cells

Modeling and Simulation of Graphene-Gated Graphene-Gaas Schottky Junction Field-Effect Solar Cell for Its Performance Enhancement

Effects on Photovoltaic Characteristics by Organic Bilayer- and Bulk-Heterojunctions: Energy Losses, Carrier Recombination and Generation

Modulating Hot Carrier Cooling and Extraction with A-site Organic Cations in Perovskites.

Influence of Phase Segregation on Recombination Dynamics in Organic Bulk-Heterojunction Solar Cells

Optimum Driving Energy for Achieving Balanced Open-Circuit Voltage and Short-Circuit Current Density in Organic Bulk Heterojunction Solar Cells

Influence of charge carrier mobility on the performance of organic solar cells

Charge Transport and Extraction of Bilayer Interdiffusion Heterojunction Organic Solar Cells

Nongeminate Recombination in Planar and Bulk Heterojunction Organic Solar Cells

Impact of charge transport on current–voltage characteristics and power-conversion efficiency of organic solar cells

An insight into effect of front surface field on the performance of interdigitated back contact silicon heterojunction solar cells

Steady-state distributions of carrier concentration and recombination rates in a solar cell under operating conditions

Leakage Current Induced by Energetic Disorder in Organic Bulk Heterojunction Solar Cells: Comprehending the Ultrahigh Loss of Open-Circuit Voltage at Low Temperatures

Current–voltage characteristics of perovskite solar cells incorporating bulk and surface recombination: comparison of a physics-based model calculations with experiments