Abstract:The absorber layers in perovskite solar cells possess a high concentration of mobile ion vacancies. These vacancies undertake thermally activated hops between neighboring lattice sites. The mobile vacancy concentration <math> N 0</math> is much higher and the activation energy <math> E A</math> for ion hops is much lower than is seen in most other semiconductors due to the inherent softness of perovskite materials. The timescale at which the internal electric field changes due to ion motion is determined by the vacancy diffusion coefficient <math> D v</math> and is similar to the timescale on which the external bias changes by a significant fraction of the open-circuit voltage at typical scan rates. Therefore, hysteresis is often observed in which the shape of the current–voltage, J–V, characteristic depends on the direction of the voltage sweep. There is also evidence that this defect migration plays a role in degradation. By employing a charge transport model of coupled ion-electron conduction in a perovskite solar cell, we show that <math> E A</math> for the ion species responsible for hysteresis can be obtained directly from measurements of the temperature variation of the scan-rate dependence of the short-circuit current and of the hysteresis factor <math> H</math>. This argument is validated by comparing <math> E A</math> deduced from measured J–V curves for four solar cell structures with density functional theory calculations. In two of these structures, the perovskite is <math> MAPbI 3</math>, where MA is methylammonium, <math> CH 3 NH 3</math>; the hole transport layer (HTL) is spiro (spiro-OMeTAD, 2,2<math> ′</math>,7,7<math> ′</math>- tetrakis[N,N-di(4-methoxyphenyl) amino]-9,9<math> ′</math>-spirobifluorene) and the electron transport layer (ETL) is <math> TiO 2</math> or <math> SnO 2</math>. For the third and fourth structures, the perovskite layer is <math> FAPbI 3</math>, where FA is formamidinium, <math> HC ( NH 2 ) 2</math>, or <math> MAPbBr 3</math>, and in both cases, the HTL is spiro and the ETL is <math> SnO 2</math>. For all four structures, the hole and electron extracting electrodes are Au and fluorine doped tin oxide, respectively. We also use our model to predict how the scan rate dependence of the power conversion efficiency varies with <math> E A</math>, <math> N 0</math>, and parameters determining free charge recombination.

Current–voltage characteristics of perovskite solar cells incorporating bulk and surface recombination: comparison of a physics-based model calculations with experiments

Analytical Model for Current-Voltage Characteristics in Perovskite Solar Cells Incorporating Bulk and Surface Recombination

Loss Mechanism Analyses of Perovskite Solar Cells with Equivalent Circuit Model

Hysteresis Modeling of Perovskite Solar Cells by an Equivalent Circuit Model

Exploring the Way To Approach the Efficiency Limit of Perovskite Solar Cells by Drift-Diffusion Model

The Role Of Exciton Delocalization In The Performance Of Bulk-Heterojunction Polymer Solar Cells

A Comprehensive Multiphysics Model for Organic Photovoltaics

Loss Mechanism Analyses of Perovskite Solar Cells with an Equivalent Circuit Model

Influences of Bulk and Surface Recombinations on the Power Conversion Efficiency of Perovskite Solar Cells

Comparison of Recombination Models in Organic Bulk Heterojunction Solar Cells

A Physics-based Analytical Model for Perovskite Solar Cells

Systematic derivation of a surface polarization model for planar perovskite solar cells

An improved model for describing the net carrier recombination rate in semiconductor devices

Insights of Hysteresis Behaviors in Perovskite Solar Cells from a Mixed Drift-Diffusion Model Coupled with Recombination

Steady-state distributions of carrier concentration and recombination rates in a solar cell under operating conditions

Role of Ionic Charge Accumulation in Perovskite Solar Cell: Carrier Transfer in Bulk and Extraction at Interface

Deducing transport properties of mobile vacancies from perovskite solar cell characteristics

A Numerical Model of P–n Junctions Bordering on Surfaces

Simulations on photovoltaic conversion in perovskite solar cells by solving hierarchical equations of motion

On the effect of surface recombination in thin film solar cells, light emitting diodes and photodetectors

Mechanism of Charge Recombination in Meso-Structured Organic-Inorganic Hybrid Perovskite Solar Cells: A Macroscopic Perspective