Abstract:The continuous decrease in feature size in the production of electronic chips has two major consequences for silicon wafers: (i) processing conditions for slicing and grinding operations need to be optimized and (ii) surface damage imposed by wafer handling and transport needs to be minimized. Cultivating a deeper understanding of the subsurface implications of contact, in particular during scratching, is necessary to achieve these goals. The active subsurface micro-deformation mechanisms, including phase transformations and crack formation, can only be measured post-scratch. On the other hand, numerical models are free of experimental constraints and can therefore serve an instrumental role in uncovering the active deformation mechanisms during scratching. However, model identification and validation with experimental data is essential for reliable simulation results. Therefore, in this paper, a numerical scratch model consisting of a continuum particle methodology combined with a large strain inelastic constitutive model is exploited, whereby the parameters are identified from indentation data. The numerical-experimental results are next compared for a range of micro-scratch tests. The experimental micro-scratch device was mounted inside a scanning electron microscope to perform in situ scratch experiments. The real-time observations at the scratched surface allowed to assess and exclude possible experimental artifacts. The simulations demonstrate the ability to investigate the evolution of the phase transformations underneath the scratched surface and relate this to the hydrostatic pressure. Notably, at the simulated subsurface phase boundary, hydrostatic tension was found which is expected to play an important role in median crack formation, as often reported in the literature. For the simulation and experiments, the steady state segments are compared and it was found that the model accurately reproduces the substantial surface recovery due to the Si-II → Si-a phase transformation. Additionally, the simulated and experimental surface cross-sectional profiles for normal scratching loads of 30, 40 and 50 mN are in adequate agreement.

In Situ Studies of Interfacial Contact Evolution Via a Two-Axis Deflecting Cantilever Microinstrument

In-situ measurements of contact evolution for fractal rough surfaces under normal compression

In Situ Observation of Nano-Abrasive Wear

From atomic attrition to mild wear at multi-asperity interfaces: The wear of hard Si3N4 repeatedly contacted against soft Si

In Situ Optical Observation of Nanoscale Contact Spots Evolution Under Normal Loading

In Situ Tem Study of Deformation-Induced Crystalline-To-Amorphous Transition in Silicon

The study of anisotropic behavior of nano-adhesive contact by multiscale simulation

Nanoindentation and Deformation Behaviors of Silicon Covered with Amorphous SiO2: a Molecular Dynamic Study

Lubrication of polycrystalline silicon MEMS via a thin silicon carbide coating

Experimental studies on the interfacial separation and stiffness of rough elastic-plastic solids

Numerical and experimental investigation on ductile deformation and subsurface defects of monocrystalline silicon during nano-scratching

Contact and Friction at Nanoscale

Design and Construction of a Micro-Tribotester for Precise In-Situ Wear Measurements

Coupled SPH-FEM modeling of Berkovich indenter scratching of single-crystal silicon

Mechanical Properties and Deformation Behaviors of Surface-Modified Silicon: a Molecular Dynamics Study

Experimental-numerical analysis of silicon micro-scratching

Effect of Surface Roughness on Nanocontact: Quasicontinuum Simulation

Eliciting stable nanoscale fracture in single-crystal silicon

Observing and Modeling the Wear Process of Heterogeneous Interface

In Situ Reflectometry and Diffraction Investigation of the Multiscale Structure of p-Type Polysilicon Passivating Contacts for c-Si Solar Cells

Phase Transformations of Mono-Crystal Silicon Induced by Two-Body and Three-Body Abrasion in Nanoscale