Abstract:To achieve a near-zero magnetic field environment, the use of permalloy sheets with high-performance magnetic properties is essential. However, mainstream welding processes for magnetically shielded rooms (MSRs), such as argon arc welding and laser welding, can degrade the magnetic properties of the material. Additionally, neglecting the anisotropy of permalloy sheets can introduce unpredictable errors in the evaluation of MSR performance. To address this issue, this paper proposes a modified model for calculating the shielding factor (SF) of MSRs that incorporates the anisotropic magnetic characteristics of permalloy sheets. These characteristics were measured using a two-dimensional single sheet tester (2D-SST). A high-precision measurement system was developed, comprising a 2D-SST (to generate two-dimensional magnetic fields and sense the induced B and H signals) and a control system (to apply in-phase 2D excitation signals and amplify, filter, and record the B and H data). Hysteresis loops were tested at low frequencies (0.1–9 Hz) and under different magnetization states (0.1–0.6 T) in two orientations—parallel and perpendicular to the annealing magnetic field—to verify anisotropy under varying conditions. Initial permeability, near-saturation magnetization, and basic magnetization curves (BM curves) were measured across different directions to provide parameters for simulations and theoretical calculations. Based on these measurements and finite element simulations, a mathematical model was developed to adjust the empirical coefficient λ used in theoretical SF calculations. The results revealed that the ratio of empirical coefficients in different directions is inversely proportional to the ratio of magnetic permeability in the corresponding directions. A verification group was established to compare the original model and the modified model. The mean squared error (MSE) between the original model and the finite element simulation was 49.97, while the MSE between the improved model and the finite element simulation was reduced to 0.13. This indicates a substantial improvement in the computational accuracy of the modified model.

Analysis of Magnetic Shielding Performance for ITER Gas Valve Boxes by Finite Element Method

Electromagnetic analyses and optimization for slit configuration of ITER blanket shield block

Numerical Analyses of Electromagnetic Forces on the ITER Blanket Module Shield Block During Major Disruptions

High Magnetic Field Shielding for Sensitive Devices Relevant to ITER

Numerical Simulation on the Shielding Efficiency of Magnetic Shielding Enclosures in the Iter Applications

Compact Multi-Layer Magnetic Shields For Chip-Scale Atomic Devices

Heat transfer coefficient calculation for analysis of ITER shield block using CFX and ANSYS

Shielding Effectiveness Characterization of Metallic Rectangular Cascaded Enclosures

Accurate Characterization. of Shielding Effectiveness of Metallic Enclosures with Thin Wires and Thin Slots

Structural Design for ITER Gas Injection System Gas Fueling Gas Valve Box

Nuclear analysis and shielding optimisation in support of the ITER In-Vessel Viewing System design

Finite Element Models for Magnetic Shields Made of Stacked Superconducting Tape Annuli

A Novel Simulation Model of Shielding Performance Based on the Anisotropic Magnetic Property of Magnetic Shields

Structural design and seismic calculation of the magnetic field immunity testing system

Development of the Coil Terminal Boxes for the ITER Magnet Feeder Systems

Electromagnetic compatibility analysis and design of ITER Poloidal Field converter unit

A description of the ITER's gas injection systems and current R&D activities

A three-step model for optimizing coil spacings inside cuboid-shaped magnetic shields

Analysis on the Shielding Effect of the Power Transformer Tank

Theoretical Analysis of a Magnetic Shielding System Combining Active and Passive Modes