Abstract:In this work, a metal–ceramic composite target for magnetron sputtering was manufactured by a robotic complex for detonation spraying of coatings equipped with a multi-chamber detonation accelerator. The powder composition (30Mo-30Al-40B4C) was sprayed onto the copper plate base of the composite target cathode. The obtained cathode target with Al-Mo-B4C coating (thickness 280–300 μm) was used to deposit the Al-Mo-B(CN) coating (DC mode) on flat specimens of AISI 316 steel and silicon using equipment for magnetron sputtering UNICOAT 200. The Al-Mo-B4C coating has a lamella-type structure with inclusions of boron carbide particles. The structure and morphology of the coatings were studied using methods of optical analysis, scanning electron microscopy, atomic force microscopy, X-ray analysis, and X-ray photoelectron spectroscopy. Mechanical and tribological properties of the Al-Mo-B(CN) thin coatings were studied using a nanoindenter, a scratch tester, and a tribometer under a fluid-free friction regime at room temperature. The Al-Mo-B(CN) coating (thickness ~1 μm) exhibited a dense homogeneous fine-grained design without columnar elements and had an amorphous structure. The formation of the MoB2 and AlN phase with an admixture of oxygen in the form of aluminum oxide, molybdenum oxide, and boron oxide was determined using XPS analysis. The Al-Mo-B(CN) coating possessed a hardness of 13 GPa, an elasticity modulus of 114 GPa, an elastic recovery of 45%, a friction coefficient of 0.8 against a steel 100 Cr6 ball, and an adhesion strength of 11 N.

Parameters research of coated MCP thermal neutron collimator

Realization and evaluation of doping and coating neutron sensitive MCP

A Numerical Model of a Coated Capillary-Plate Thermal Neutron Collimator

Realization of neutron sensitive MCP with ALD technique

High Detection Efficiency Neutron Sensitive Microchannel Plate

Neutron collimator design of neutron radiography based on the BNCT facility

Study of the Response of 10B-Doped MCP to Wide-Energy Range Neutrons from Ev to MeV

Detection Efficiency and Spatial Resolution Analysis of a Nmcp Detector

Investigation of the Al-Mo-B(CN) Coatings Deposited Using Magnetron Sputtering of Al-Mo-B4C Target Produced by Detonation Spray Coating

Neutron Detector Design Based on ALD Coated MCP

Detection Ffficiency And Spatial Resolution Analysis Of A (Mcp)-M-N Detector

High efficiency event-counting thermal neutron imaging using Gd doped micro channel plate

A Thermal Neutron Imaging Detector Using a Gd-doped Micro-Channel Plate

Design of moderator and collimator based on compact D-T neutron source for neutron imaging

Neutron imaging and tomography with MCPs

Simulating the secondary electron avalanche of MCP by Geant4

The design of a novel neutron shielding B4C/Al composite containing Gd

High Efficiency Event-Counting Thermal Neutron Imaging Using a Gd-doped Micro-Channel Plate

Experimental Research on A Boron-Coated Multi-Wire Proportional Chamber Neutron Detector

Influence of Original Powders on the Microstructure and Properties of Thermal Barrier Coatings Deposited by Supersonic Atmospheric Plasma Spraying, Part Ii: Properties