Abstract:Purpose The purpose of this study is to analyse the problem of high binder content in sand mould and to solve it. Meanwhile, to increase build speed, especially for heavy casting’s sand mould with a high value in layer height, such as 2 mm in construction instead of the industry standard of 0.3 mm, line forming for three-dimensional (3D) sand mould printing is researched. Design/methodology/approach Brief introduction of 3D sand mould printing and key issues are given first. Then, this paper quantitatively analyses binder content in sand mould. Finally, to acquire sand mould with appropriate binder content and high build speed, line forming combining traditional furan no-bake sand manufacture technique is researched, as well as relevant feasible schemes and current progress. Findings The study shows that compared with traditional technique, binder content in sand mould produced by available 3D printing technique is too high, bad for sand mould’s properties and quality of castings, while line forming brings guaranteed binder content and improved build speed. Research limitations/implications More experiments are needed to demonstrate quantitative analysis of binder content and to obtain flowability of moist sand, detailed structure design of nozzle and practical build speed, as well as methods of circulation of materials considering solidification time. Practical implications Line forming with higher build speed and suitable binder content means excellent properties of sand mould and castings as well, bringing obvious implication for moulds industries and manufacturing industry. Originality/value This new method could increase build speed and meanwhile guarantee binder content. Thus, its application prospect is promising.

Study on Aeration Sand Filling Process

Experimental Study of Sand Filling Process of Aeration Filling and High Pressure Squeezing Flaskless Moulding Machine

3D numerical simulation for aeration sand filling process ( draft )

3D numerical simulation of high pressure squeezing process with revised Drucker Prager/Cap model

Fabrication and posttreatment for inorganic binder jetting sand molds for casting

A Study on the Numerical Simulation of Shoot-squeeze Moulding

Dynamic Analysis of Unbonded Sand During Filling for EPC

Water Analogue Experimental Study on the Filling Process of A Steam Turbine Housing Casting

Numerical Simulation of Compacting Process of Green Sand Molding Based on Sand Filling

Digital High-Efficiency Print Forming Method and Device for Multi-Material Casting Molds

Effects of Hollow Structures in Sand Mold Manufactured Using 3D Printing Technology

Influence of Process Parameters on Filling Ability of A356 Aluminium Alloy in Expendable Pattern Shell Casting with Vacuum and Low Pressure

Research on forming method of additive manufacturing of frozen sand mold

A New Sand Casting Process with Accelerated Solidification Rate

Research on Key Technique of Line Forming for 3D Sand Mould Printing Based on Quantitative Analysis of Binder Content

183/1 Research on mould filling process of melt in vertical centrifugal casting

Study of Mold Filling Simulation on Low Pressure Die Casting for Automobile Wheel Casting

Insulation Effect of Air Cavity in Sand Mold Using 3D Printing Technology

Experimental Study on the Filling Process of the Lost Foam Casting Process of a Cast Iron Plate

Dynamic Model of Mold Filling Process under Low Pressure Casting

Numerical Simulation and the Application for Filling Process of Expendable Polystyrene Beads in Lost-foam Casting