Abstract:This research delves into the primary issue of polyimide (PI) insulation failures in high-frequency power transformers (HFPTs) by scrutinizing partial discharge development under high-frequency electrical stress. This study employs an experimental approach coupled with a plasma simulation model for a ball–sphere electrode structure. The simulation model integrates the particle transport equation, Poisson equation, and complex chemical reactions to ascertain microscopic parameters, including plasma distribution, electric field, electron density, electron temperature, surface, and space charge distribution. The effect of the voltage polarity and electrical energy on the PD process is also discussed. The contact point plays a pivotal role in triggering partial discharges and culminating in the breakdown of PI insulation. Asymmetry phenomena were found between positive and negative half-cycles by analyzing the PD data stage by stage. A significant number of PDs increased at every stage and the PD amplitude was higher during the negative cycle at the initial stage, but in later stages, the PD amplitude was found to be higher in the positive half-cycle, and scanning electron microscopy (SEM) revealed that the maximum damage occurred near the contact point junction. The simulation results show that the plasma initially accumulates the electron density near the contact point junction. Under the action of the electric field, plasma starts traveling at the PI surface outward from the contact point. Before the PD activity, all parameters have higher values in the plasma head. The microscopic parameters reveal maximum values near the contact point junction, during PD activities where significant damage takes place. These parameter distributions exhibit a decreasing trend over time as when the PD activity ends. The model's predictions are consistent with the experimental data. The paper lays the foundation for future research in polymer insulation design under high-frequency electrical stress.

Evaluation of VPI Insulating Materials and Insulation System

Development Of Insulation Technology With Vacuum-Pressure-Impregnation (Vpi) For Iter Correction Coil

Research on the Design and Thermal Performance of Vacuum Insulation Panel Composite Insulation Materials

Results of Vacuum-Pressure Impregnation of the PF1 Coil Ground Insulation

Preparation of PI porous fiber membrane for recovering oil-paper insulation structure

Research Progress and Prospect of Condition Assessment Techniques for Oil–Paper Insulation Used in Power Systems: A Review

Vacuum Insulation Panels: Analysis of the Thermal Performance of Both Single Panel and Multilayer Boards

Study on Stator Winding Degradation under Bar Vibration

An Energy-Efficiency, Performance Study of, Vacuum Insulation Panels

R&D of Insulating and Vacuum Pressure Impregnation Equipment for PF1 Coil Double Pancakes

Preparation and Characterization of a Type of Green Vacuum Insulation Panel Prepared with Straw Core Material

Investigation of Partial Discharge Transformation Characteristics in Polyimide (PI) Insulations under High-Frequency Electric Stress

Influence of Thermal Aging on the Evolution of Dielectric and Physical Properties in Resin-impregnated Paper

ANALYSIS ON THERMAL INSULATION PERFORMANCE AND INFLUENCE PARAMETERS OF VACUUM INSULATION PANEL

Research on thermal insulation performance and application simulation of high-temperature vacuum insulation panel

Numerical analysis and experimental investigation on thermal bridge effect of vacuum insulation panel

The Investigation of Electrical Properties for Mica/Epoxy Insulation Stator Bars During the Thermal Cycle Aging Test

Research on Insulation Technology for Nb3Sn Layer Coil of Superconducting Conductor Testing Facility

Study on VPI Process of Epoxy Impregnating Resin for Cryogenic Superconducting Magnets in TOKAMAK

The Degradation Assessment of Epoxy/mica Insulation under Multi-Stresses Aging

Excellent electrical performance and thermal properties insulation paper based on polyimide porous fiber membrane modified by nano-SiO2