Abstract:Copper wire bonding process is widely used in the electronic packaging of system integration with various heterogeneous and homogeneous components due to the advantage of cost. In this paper, an achievement of parallel microgap resistance welding with 40-μm copper wire on 300-nm Au-plated quartz pendulous reed used in precision mechanical and electrical product was presented. Research on orthogonal design of experiment was carried out, and the effect of process parameters was discussed on the shape of bonding interface, tensile force, and shear force by variance analysis. It is shown that too large a heat input and electrode pressure can cause the gold layer to wrinkle or fuse and cause bonding interface mechanics performance to fall sharply. A group of optimized process parameters (0.84 N of bonding pressure, 0.45V of bonding voltage, and 17 ms of bonding time) is obtained. Reliability tests including the thermal shock, random vibration, and electric aging tests on optimized process parameters were carried out, and the mechanical properties and physical properties of the bonding interface were mainly focused. It is shown that the bonding interface resistance increases slightly and the overall bonding interface tensile strength falls slightly after 500 cycles of thermal shock test. However, there is no change during the random vibration process. When electric aging time is less than 200 h, bonding interface morphology does not change and there is no crack. When electric aging time is 360 h, bonding interface deforms and crack occurs. When electric aging time reaches 720 h, bonding interface crack area increases, and it eventually fails. It is experimentally proved that a bonding interface with better performance can be achieved by parallel microgap resistance welding with 40-μm copper wire on 300-nm Au-plated quartz pendulous reed.

Factors Governing Heat Affected Zone During Wire Bonding

Heat Affected Zone in the MEMS Wire Bonding

Simulation and Experimental Analysis of Thermomechanical Stress Around Interconnects for W2W Hybrid Bonding

Impact of Process Parameters on Forming Quality and Deposition Efficiency of Unsupported Rods in Wire Arc Additive Manufacturing

Study on Electro-Thermo-Mechanical Responses of Bonding Wires Arrays Used for the Package Design of Ldmosfet-Based Rf Amplifier

Electro-Thermo-Mechanical Characterizations of Various Wire Bonding Interconnects Illuminated by an Electromagnetic Pulse

Electromagnetic Characteristics of Bonding Wires in Advanced Electronic Devices Packaging

Experiment study of temperature parameter effect on bonding process and quality in thermosonic wire bonding

Study of Temperature Parameter in Au–Ag Wire Bonding

Optimization on Parameters of Electronic Flame off Process of Ball Bonds with Fine Diameter Copper Wire

Wire Arc Additive Manufacturing of ZL205A: Heat Input Effect on the Forming Quality、pore Defects and Mechanical Properties

Finite Element Analysis of Wire Bonding Non-Stick Issue in Miniaturized Package Development

Effect of Induction Heat Treatment on Residual Stress Distribution of Components Fabricated by Wire Arc Additive Manufacturing

Effect of Heat Input on Failure Mode and Connection Mechanism of Parallel Micro-Gap Resistance Welding for Copper Wire

Temperature Effect in Thermosonic Wire Bonding

Mechanical Issues of Cu-to-Cu Wire Bonding

Research on 0.6 mil Ag-8Au-3Pd alloy wire bonding process

Ruggedness Characterization of Bonding Wire Arrays in LDMOSFET-Based Power Amplifiers

Experiments and reliability research on bonding process of micron copper wire and nanometer gold layer

Progress in ultrasonic bonding wire process and quality evaluation of bonding point