Abstract:The electron beam wire-feed additive manufacturing (EBAM) technology utilizes a high-energy electron beam as a heat source to bombard a metal wire in the vacuum environment to form a molten pool. The stability and quality of the deposition mainly depend on the transition behavior of the droplet. To conduct this research, a high-fidelity thermo-fluid dynamic simulation model based on the local reconstruction of the 3D model was developed and verified. The model used the Monte-Carlo algorithm to update the scattering trajectories and residual energies of high-energy electrons on the irradiated surface of the wire and molten pool at each time step in the numerical calculation. Quantitatively analyzed the "electron-wire" instantaneous energy coupling mechanism in the droplet transition mode, insertion transition mode, and liquid bridge transition mode, and finally established an energy-matching criterion for maintaining a stable deposited track morphology. The results show that during the initial stage of wire melting, the droplet will climb along the wire feeding direction, grow under gravity, and eventually drop under the combined effects of gravity and recoil pressure. Different forms of molten droplets will form various solidification morphology, with the liquid bridge transition mode being the most desirable. To maintain a stable liquid bridge transition, it is necessary to control the droplet generation height within the range of 0-2.7 mm. The collapse of the deposited track, caused by heat accumulation during the multilayer deposition, would also alter the droplet generation height. Therefore, to maintain the liquid bridge transition mode in the multilayer multi-channel forming process, it is also necessary to ensure that the energy density of the deposited track is slightly greater than 1.16x1010 J/m3 and the energy density of the wire is slightly greater than 2.63x1010 J/m3.

Heat Affected Zone in the MEMS Wire Bonding

Factors Governing Heat Affected Zone During Wire Bonding

Simulation and Experimental Analysis of Thermomechanical Stress Around Interconnects for W2W Hybrid Bonding

Study on Electro-Thermo-Mechanical Responses of Bonding Wires Arrays Used for the Package Design of Ldmosfet-Based Rf Amplifier

Laser-heating Wire Bonding on MEMS Packaging

Ruggedness Characterization of Bonding Wire Arrays in LDMOSFET-Based Power Amplifiers

Impact of Process Parameters on Forming Quality and Deposition Efficiency of Unsupported Rods in Wire Arc Additive Manufacturing

Electromagnetic Characteristics of Bonding Wires in Advanced Electronic Devices Packaging

Effect of Induction Heat Treatment on Residual Stress Distribution of Components Fabricated by Wire Arc Additive Manufacturing

Wire Arc Additive Manufacturing of ZL205A: Heat Input Effect on the Forming Quality、pore Defects and Mechanical Properties

Simulation of Wire Bonding Process Using Explicit Fem with Ale Remeshing Technology

Experiment study of temperature parameter effect on bonding process and quality in thermosonic wire bonding

Mechanical Issues of Cu-to-Cu Wire Bonding

Research on Fatigue Properties of Micron Scale Copper Bonding Wires

Temperature Effect in Thermosonic Wire Bonding

Influence of Thermal Boundary Effects on the Process of Creating Recovery Stresses in a SMA Wire Activated by Joule Heating

Effect of Heat Input on Failure Mode and Connection Mechanism of Parallel Micro-Gap Resistance Welding for Copper Wire

Heat and Mass Transfer in Electron Beam Additive Manufacturing

Study of Temperature Parameter in Au–Ag Wire Bonding

Experimental Study on the Effect of Wire Bonding by Cu Electroplating on GMI Stability of Co‐based Amorphous Wires