Abstract:In this work, CuO-doped SnO2 (CuO/SnO2) nanoparticles with different CuO mass fractions (0-1.0 wt%) are synthesized by a flame spray pyrolysis (FSP) route and applied to fabricate thin-film gas sensors for H2S detecting. The nanoparticles are characterized by X-ray diffraction (XRD), N-2-physisorption isotherms, transmission electron microscopy (TEM) and X-ray photoelectron spectroscopy (XPS). Within the 0-1.0 wt% CuO-doping concentrations, all of the nanoparticles predominantly exhibit a spherical structure with a diameter of 5-15 nm, and possess a quite large specific surface area (110-125 m(2) /g). These textural characterizations suggest that Cu atoms form substitution doping in polycrystalline SnO2 nanoparticles at low CuO levels (< 0.5 wt%), and they are segregated as CuO nanoclusters at high CuO concentrations (0.5-1.0 wt%). From gas-sensing measurements, the CuO doping significantly improves the H2S sensing performance of SnO2 nanoparticles, especially at the optimal CuO-doping mass fraction of 0.5 wt%. The optimal CuO-doped SnO2 gas sensor exhibits a highest response (Ra /Rg = 1056) under a condition of 10 ppm H2S atmosphere at 125 degrees C. This is probably because a large number of highly dispersed small CuO nanoclusters are supported on the surface of the nanoparticle for 0.5 wt% doping, forming abundant p-n junctions with SnO2. When the CuO/SnO2 composite is exposed to H2S, semiconducting CuO is converted to metallic-like CuS, thereby increasing electrical conductivity and resulting in a high response. In addition, the optimal sensor displays good cycle performance and high H2S selectivity against other toxic and flammable gases including NH3, H-2 and CO. Therefore, the gas sensor of 0.5 wt% CuO-doped SnO2 made by the FSP shows a large potential for H2S detecting in practical industrial application. (C) 2020 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Development of a novel H 2 S gas sensor based on CuO-doped SnO 2 hollow nanospheres

Development of Sensors Based on CuO-doped SnO2 Hollow Spheres for Ppb Level H2S Gas Sensing

Sensitive H2 Gas Sensors Based on SnO2 Nanowires

Photoelectric H2S Sensing Based on Electrospun Hollow CuO-SnO2 Nanotubes at Room Temperature

Ultrasensitive H2S Gas Sensor Based on SnO2 Nanoparticles Modified WO3 Nanocubes Heterojunction

High-response H2S sensor based on ZnO/SnO2 heterogeneous nanospheres

Flame spray pyrolysis synthesis and H<sub>2</sub>S sensing properties of CuO-doped SnO<sub>2</sub> nanoparticles

Hydrogen Gas Sensor Based on SnO2 Nanospheres Modified with Sb2O3 Prepared by One-Step Solvothermal Route

Preparation and Gas-Sensing Performances of ZnO/CuO Rough Nanotubular Arrays for Low-Working Temperature H2S Detection

Carbon Nanotubes-Cuo/sno2 Based Gas Sensor for Detecting H2S in Low Concentration

Ultrafine Nanoparticles of W-doped SnO2 for Durable H2S Sensors with Fast Response and Recovery.

H2S Detection Sensing Characteristic of CuO/SnO2 Sensor

ZnO@CuO hollow nanospheres based composites used for sensitive detection of hydrogen sulfide with long-term stability

Studies on Sensing Properties and Mechanism of CuO Nanoparticles to H2S Gas

An olive-shaped SnO2 nanocrystal-based low concentration H2S gas sensor with high sensitivity and selectivity

CuO nanosheets for sensitive and selective determination of H2S with high recovery ability

ZnO@CuO Hollow Nanosphere-Based Composites Used for the Sensitive Detection of Hydrogen Sulfide with Long-Term Stability

Solution-processed SnO2 nanowires for sensitive and fast-response H2S detection

H2S Detection at Low Temperatures by Cu2O/Fe2O3 Heterostructure Ordered Array Sensors

Highly Selective and Fast Response/Recovery Cataluminescence Sensor Based on SnO2 for H2S Detection

ZnO-CuO Hollow Nanocages Derived from Metal–Organic Frameworks for Selective H2S Sensing