Abstract:The dynamic flow deformation of liquefied saturated sand may cause serious damages to the ground and underground structures. However, to investigate the static fluid characteristics of the post-liquefied saturated sand, most studies on this problem have applied the cyclic loading to the saturated sand samples first, and then used the monotonic loading. The above test loading process is different from the actual stress state of soil in site. To investigate the dynamic flow characteristics of the liquefied saturated Nanjing sand under the cyclic loading, a series of undrained cyclic torsional shear tests are performed by using the hollow column torsional shear apparatus, with the largest shear strain up to 100%. At the same time, different effective confining pressure, initial shear stress and cyclic loading amplitude are loaded on the soil samples respectively. It is found that the soil sample has been in shear dilation state at the end of "zero effective stress" stage which is only determined by the excess pore pressure ratio. In other words, the response of excess pore pressure should be hysteretic to the shear dilation of the samples. It also proves that the initial shear stress should have the greatest influence on the relationship curves of the apparent viscosity-strain rate and the shear strain rate in the "zero effective stress" stage. Meanwhile, the dynamic apparent viscosity of sand in the "zero effective stress" stage under the cyclic loading is larger than the static apparent viscosity of post-liquefied sand when the shear strain rate reaches a relatively small value. Based on the test results, the dynamic apparent viscosity of liquefied sand should not be predicted by the empirical equation derived from the static fluid characteristics of the post-liquefied saturated sand.

Experimental Study on Strength and Deformation Characteristics of Saturated Sand after Liquefaction

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Energy-based Assessment of Cyclic Liquefaction Behavior of Clean and Silty Sand under Sustained Initial Stress Conditions

Flow Deformation and Cyclic Resistance of Saturated Loose Sand Considering Initial Static Shear Effect

Experimental Investigation on Fluid Characteristics of Medium Dense Saturated Fine Sand in Pre- and Post-Liquefaction

Liquefaction of Sand under Monotonic and Cyclic Shear Conditions: Impact of Drained Preloading History

Shear moduli reduction of saturated Nanjing sand under large deformation induced by liquefaction

Experimental Study on the Influence of Cyclic Loading Frequency on Liquefaction Characteristics of Saturated Sand

Dynamic Flow Characteristics Of Liquefied Sand Under The Extrema Large Deformation In The Cyclic Torsional Shear Tests

Behaviour of Large Post-Liquefaction Deformation in Saturated Sand-Gravel Composites

Experimental studies on dynamic and static properties of sand during repeated liquefaction events

DEM study of mechanism of large post-liquefaction deformation of saturated sand

Experiment and Numerical Simulation of Repeated Liquefaction-Consolidation of Sand

Comparative Study on the Post-Liquefaction Behaviour of Saturated Sand and Sand-Gravel Composites

A New Parameter to Evaluate Liquefaction Resistance of Saturated Sand under Complex Dynamic Stress Paths

Triaxial Tests on the Fluidic Behavior of Post-Liquefaction Sand

Comparison of Cyclic Liquefaction Behavior of Clean and Silty Sands Considering Static Shear Effect

A Cyclic Elasto-Plastic Constitutive Model for Evaluating Large Liquefaction-Induced Deformation of Sand

Soil Dynamic Constitutive Considering Post-Liquefaction Deformation and Reversible Pore-Water Pressure

Shear modulus reduction of saturated sand under large liquefaction-induced deformation in cyclic torsional shear tests

Apparent kinetic viscosity of saturated Nanjing sand due to liquefaction-induced large deformation in torsional shear tests