Abstract:Digital terrestrial television multimedia broadcasting-advanced (DTMB-A) has just been announced as one of the second generation digital terrestrial television broadcasting (DTTB) standard. In comparison with digital terrestrial television multimedia broadcasting (DTMB) standard, DTMB-A has innovations and upgrades in many aspects, including coding and modulation, which are essential modules in DTTB system. Low-density parity-check (LDPC) codes and amplitude phase shift keying constellations with Gray-mapping (Gray-APSK) are adopted. Bit-interleaved coded modulation with iterative demapping (BICM-ID) is also introduced, which is proved capable of obtaining performance gain comparing to conventional independent demapping. However, few quantitative results of the BICM-ID receiver under DTMB-A standard are presented. Comparison between DTMB-A and other DTTB standards is also deficient. In addition, introduction of iterative demapping (ID) makes hardware implementation more complex. Processing and scheduling strategies are different and more hardware resources are demanded, which indicates that more detailed studies are needed. This paper gives quantitative results of BICM-ID and BICM receiver under DTMB-A standard via both performance analysis and simulation, and makes comparison with other DTTB standards. Utilization of hardware resources is also evaluated and presented. The results show that in typical DTMB-A terrestrial broadcasting mode (256 Gray-APSK and 2/3-rate long LDPC codes), BICM-ID receiver brings 0.4 dB gain in the additive white Gaussian noise (AWGN) channel comparing to BICM receiver and its performance is better than those under the same conditions of other standards. Register transfer level (RTL) synthesis from hardware implementation is carried out and shows that limited extra hardware resources are needed to support II).

Combined Turbo Equalization in BICM-ID

Turbo Equalization and Its Improvement in BICM-ID Based on Hard-Decision

Channel Estimation Algorithm for Mobile OFDM Receivers

Turbo Equalization System Combined with Turbo Product Codes

Improved Turbo Equalization Based on Soft ISI Cancellation

The Improvement Of Turbo Equalization Through Using Turbo Codes

The Joint Demodulation and Decoding for BICM-ID System with BEC Approximation and Optimized Bit Mapping

Turbo Equalization with Coarse Quantization using the Information Bottleneck Method

Turbo Equalization For Waveforms Encoded By Reed Solomon Codes

Implementation of BICM-ID Receiver for Coded Modulation in DTMB-A

BICM-ID Systems with Signal Space Diversity over Rayleigh Fading Channels.

An Equalization Algorithm Based on Serial and Parallel Concatenation Turbo-like Method

Mimo-Sc-Fdma System with Iterative Decision Feedback Equalization

Performance analysis of bit-cooperative coded modulation with turbo codes.

Turbo equalizer of ultra-wideband transmitted-reference receiver under inter-symbol interference

Performance Analysis of Different Equalization Algorithms in a Modified Iterative Scheme

On BICM receivers for TCM transmission

Design of BICM-ID for two-way relay channels

Turbo equalization based on compressive sensing channel estimation in wideband HF systems

Iterative demodulation and decoding of turbo-coded M-ary noncoherent orthogonal modulation

Adaptive MMSE Algorithm Used in Turbo Iterative SoIC of V-Blast System.