EXIT-constrained BICM-ID design using extended mapping
Kisho Fukawa,Soulisak Ormsub,Antti Tölli,Khoirul Anwar,Tad Matsumoto
DOI: https://doi.org/10.1186/1687-1499-2012-40
2012-02-09
EURASIP Journal on Wireless Communications and Networking
Abstract:This article proposes a novel design framework, EXIT-constrained binary switching algorithm (EBSA), for achieving near Shannon limit performance with single parity check and irregular repetition coded bit interleaved coded modulation and iterative detection with extended mapping (SI-BICM-ID-EM). EBSA is composed of node degree allocation optimization using linear programming (LP) and labeling optimization based on adaptive binary switching algorithm jointly. This technique achieves exact matching between the Demapper (Dem) and decoder's extrinsic information transfer (EXIT) curves while the convergence tunnel opens until the desired mutual information (MI) point. Moreover, this article proposes a combined use of SI-BICM-ID-EM with Doped-ACCumulator (D-ACC) and modulation doping (MD) to further improve the performance. In fact, the use of D-ACC and SI-BICM-ID (noted as DSI-BICM-ID-EM) enables the right-most point of the EXIT curve of the combined demapper and D-ACC decoder (Ddacc), denoted as DemDdacc, to reach a point very close to the (1.0, 1.0) MI point. Furthermore, MD provides us with additional degree-of-freedom in "bending" the shape of the demapper EXIT curve by choosing the mixing ratio of modulation formats, and hence the left most point of the demapper EXIT curve can flexibly be lifted up/pushed down with MD aided DSI-BICM-ID-EM (referred to as MDSI-BICM-ID-EM). Results of the simulations show that near-Shannon limit performance can be achieved with the proposed technique; with a parameter set obtained by EBSA for MDSI-BICM-ID-EM, the threshold signal-to-noise power ratio (SNR) is only roughly 0.5 dB away from the Shannon limit, for which the required computational complexity per iteration is at the same order as a Turbo code with only memory-2 convolutional constituent codes.
telecommunications,engineering, electrical & electronic