Abstract:During AC-side fault ride-through of the Baihetan-Jiangsu ±800 kV hybrid DC transmission project, a controlled self-recovery dissipation device was added in order to limit the overvoltage absorption of redundant energy on the flexible bus. In order to achieve a rapid 1 ms input of the controlled self-recovery dissipation device, a DC 80 kV SF 6 /N 2 plasma jet trigger gap needs to be developed. According to the engineering requirements, the engineering application conditions were analyzed and the key technical requirements for the trigger gap were clarified. To meet the requirements of high performance triggering, a high voltage pulse type plasma. double-stage succession triggering method is proposed, a coaxial laminated type productized triggering chamber was designed, a test platform for triggering characteristics was set up, a test study of triggering performance was carried out, and a method for online monitoring of triggering performance by monitoring the voltage change of the energy storage capacitor during the triggering process was proposed. The research results show that the minimum triggerable voltage is 50 kV, the trigger time delay is 0.3 ms, and the no-load trigger life is 1800 times. In order to meet the requirements of large direct-current flow and fast insulation recovery, the design of the main electrode of the spin-arc was completed based on the principle of transverse magnetic electrode spin-arc, and the electric field and spin-arc simulation was carried out. The results show that the arc is capable of rotating at high speed along the edge of the main electrode, recovering to withstand 1.5 times the rated voltage in 0.1 s after 30 kA/50 ms through-current, and withstanding 50 through-current cycles. Based on the solution of the above key issues, the structural design of the dual redundant plasma jet trigger gap body and the high potential measurement and control package was completed. The prototype has been developed and verified by the third party performance tests. The key technical indicators of insulation, triggering and through-current fully can meet the requirements of the Baijiang project and will be applied in the project.

Development of the Multichannel HV IGBT Driver Trigger Based on FPGA

Application of FPGA in High-Power Multiphase Variable Speed Drives

Design of a New Trigger Circuit for Three-phase Semicontrol Bridge

Advanced Active Gate Drive for Switching Performance Improvement and Overvoltage Protection of High-Power IGBTs

A novel active gate drive for HV-IGBTs using feed-forward gate charge control strategy

Development of DC 80 kV SF6/N2 Plasma Injection Trigger Gap for±800 kV Hybrid DC Transmission Project

Design of IGBT Driver in High Voltage PFN Charging Power Supply

A Driving Pulse Edge Modulation Technique and Its Complex Programming Logic Devices Implementation.

Development of Coaxial Discharge Multi-Output Pusle Trigger with Fast Rise Time Based on High Voltage Silicon Reactor Rectifier Energy Storage

An FPGA-Based Voltage Balancing Control for Multi-HV-IGBTs in Series Connection

Development of a sub-nanosecond jitter eight-output 150-kv trigger generator*

Adaptive Digital Gate Control For Series Connected Igbts

Design of voltage balancing control circuit for series connected HV-IGBTs

Modeling and simulation of three-phase IGBT full-bridge inverter circuit based on FPGA

Model Analysis and Simulation of a Self-Trigger LTD Module

A Multi-Channel Digital Programable Delay Trigger System with High Accuracy and Wide Range

High Voltage Insulated Gate Trigger Thyristor With High-Efficiency Injection for Fast Turn-on and High Current Pulse

4.5Kv Insulated Gate Triggered Thyristor (IGTT) with High $di/dt$ Characteristics for Pulse Power Applications

A High-reliability Half-Bridge GaN FET Gate Driver with Advanced Floating Bias Control Techniques

Magnetically and Optoelectronically Isolated Trigger for Pulse-Power Applications

FPGA-based Multilevel Direct PWM Generator for H-bridge Inverters