Abstract:It is seen that with the reduction in land areas owing to the floating-rings featured grooves, there is reduction in the load capacities and bearing torques of the oil-films, which have an influence on the nonlinear oscillations of turbocharger rotors. In the present paper, the impact of the reduced load capacities and bearing torques caused by circumferential or/and axial grooves in full-floating-ring bearings on the nonlinear oscillations of turbocharger rotors is investigated. The numerical solution of the Reynolds equation for full-floating-ring bearings with grooves by means of a finite difference or finite element approach imposes a prohibitive simulation times, sine in every time-integration step a direct discretization of the Reynolds equation has to be solved simultaneously with the rotor model. To be able to perform transient simulations, a computationally efficient full-floating-ring bearing model is mandatory. To surmount this problem, a very time-efficient but rather precise method is proposed. The major point of the proposed method is the manipulation of the Reynolds equation to allow a speed parameter varying within (−1, +1) to reflect the relative weights of the journal and floating ring’s rotation and squeezing effects. Given the diameter-to-length ratio of each fluid film, groove widths, and boundary conditions, the fluid force databases can be easily established by the finite difference method. During the transient response analysis, the required fluid forces and bearing torques from each film can be evaluated by interpolation using the existent forces and torques of the closest points in the databases. Using transient simulations with the proposed method, the effect of circumferential or/and axial grooves in full-floating-ring bearings on the amplitudes and frequencies of the nonlinear oscillations of turbocharger rotors is qualitatively investigated. It is shown that the reduction of the load capacities and bearing torques due to grooves exert a large influence on the nonlinear rotor oscillations.

Turbocharger Rotor Dynamics Considering Engine's Foundation Excitation

Turbocharger rotor dynamics with foundation excitation

Nonlinear Dynamical Behaviors of A Cracked Turbocharger Rotor System with Base Excitation

Modeling a Two-Span Rotor System Based on the Hamilton Principle and Rotor Dynamic Behavior Analysis

Vibration Analysis of a Nonlinear Rotor-Bearing-seal System

Study on Model of Continuous Rotor under Steam Seal Force

Effect of rotating unbalance and engine excitations on the nonlinear dynamic response of turbocharger flexible rotor system supported on floating ring bearings

Dynamic characteristics of high-speed gasoline engine turbocharger based on thermo-elasto-hydrodynamic lubrication bearing model and flexible multibody dynamics method

The Influence of Ring-Speed Ratio Dynamic Change on Nonlinear Vibration Response of High-Speed Turbocharger Rotor System

Dynamic stability analysis of a high-speed diesel engine turbocharger subjected to aerodynamic loads and engine-induced vibration

Effects of Circumferential and Axial Grooves on the Nonlinear Oscillations of the Full Floating Ring Bearing Supported Turbocharger Rotor

Nonlinear Dynamic Analysis Of A Rotor-Labyrinth Seal-Bearing Foundation System

Investigation of Weight Effects on the Critical Speed of Inclined Turbocharger Rotor System

Dynamic Analysis of Turbocharger Rotor Bearing with an Integrated Three Dimensional Thermohydrodynamic Model

Dynamic Analysis of Rotor'S Radial Rub-Impact in Full Degrees of Freedom Accounting for Turborotor'S Non-Linear Clearance-Excitation Force

Study On The Nonlinear Model Of Continuous Rotor And Its Solution

Dynamic Analysis of High Speed Turbine Rotor with Foil Bearing

Foundation Excitation Idetification of Turbocharger's Vibration Response Based on Frequency Response Function Inversion Method

Nonlinear Dynamic Analysis of a Rotor/bearing/seal System

Nonlinear Transient Response of Tilting 4 Pad Bearings: Turbocharger Systems

Effects of unbalance orientation on the dynamic characteristics of a double overhung rotor system for high-speed turbochargers