Abstract:Purpose: The pulse line ion accelerator (PLIA) is a low-cost accelerator concept originally designed to accelerate heavy ions. Our group has been investigating the use of PLIA to accelerate light ions and believe a multi-stage PLIA could be useful for short half-life PET isotope production. The goal of this work was to develop a single prototype fast PLIA structure and demonstrate electromagnetic wave propagation using a high-voltage pulser. Materials and methods: A 1.6 m fast PLIA structure (wave speed > 107 m/s) was constructed along with a high-voltage, sinusoidal pulse generator. The latter uses capacitive voltage doubling and spark gap switching. A step-up transformer couples voltage from the pulser to the PLIA coil. Voltage measurements on the coil were made in air using a high-voltage resistive probe, while capacitive probes placed along the length of the PLIA were used to measure wave propagation with the PLIA structure filled with transformer oil. Results: Voltage measurements acquired on the primary and secondary coils of the transformer coupler in air demonstrated a peak-to-peak voltage step-up of 4.2 relative to the pulser DC charging voltage. The maximum voltage time-rate-of-change on the PLIA coil was 0.76 × 1013 V/s. Capacitive probe measurements indicated voltage oscillations on the PLIA coil with half-period equal to 43 ± 0.9 ns and wave speed (with oil) of 1.2 × 107 m/s. Average and peak accelerating gradients were conservatively estimated to be 0.44 and 0.60 MV/m, respectively, with a charging voltage of 55 kV. Wave propagation was demonstrated at these gradients without flashover at a vacuum pressure of 9 × 10-6 Torr. Submerging the pulser in oil would allow for charging voltages up to 150 kV and produce accelerating gradients >1.2 MV/m. Conclusions: Use of a multi-stage, fast PLIA for light ion acceleration could provide a low-cost complement to cyclotrons for the production of short half-life isotopes used for PET imaging, including carbon-11, nitrogen-13, oxygen-15, and fluorine-18.

Experimental research of double-pulse linear induction electron accelerator

Development of Mini-LIA and Primary Experiments

An introduction to Mini-LIA

Beam characterizations of the Mini-LIA

Special Way of Increasing Linear Energy Transfer Value Used for Study on Single Event Effect

Acceleration Modules in Linear Induction Accelerators

3.5 MeV Pulsed Power System for LIA Injector

Design and Characterization of A High-Power Induction Module at Megahertz Repetition Rate Burst Mode

Electromagnetic wave propagation in a fast pulse line ion accelerator

Status of the Los Alamos heavy ion injector

Measurement of electron beam energy from Mini-LIA by solenoid-induced beam rotation

Time-Resolved End-to-End Simulations of Beam-Pulse Timing Effects in a Linear Induction Accelerator

Prototype of Multi-Filament Electron Curtain Accelerator

E-field Measurement of a Pulse Line Ion Accelerator

An Electron-Beam Accelerator Based on Spiral Water PFL

Model of a 5-MA Linear-Transformer-Driver Accelerator: Comparison of MITL Performance for Bremsstrahlung Electron Beam Diodes and Z-Pinch Loads

Multipactor Experiment on A Micro-Pulse Electron Gun

High Energy Electron Radiography Experiment Research Based on Picosencond Pulse Width Bunch

A 2.45 Ghz Electron Cyclotron Resonance Proton Ion Source and A Dual-Lens Low Energy Beam Transport

Milliampere He 2 + Beam Generator Using a Compact GHz ECRIS

A spiral strip transformer type electron-beam accelerator