Abstract:Purpose: The pulse line ion accelerator (PLIA) is a low-cost accelerator concept originally designed to accelerate heavy ions. Our group has been investigating the use of PLIA to accelerate light ions and believe a multi-stage PLIA could be useful for short half-life PET isotope production. The goal of this work was to develop a single prototype fast PLIA structure and demonstrate electromagnetic wave propagation using a high-voltage pulser. Materials and methods: A 1.6 m fast PLIA structure (wave speed > 107 m/s) was constructed along with a high-voltage, sinusoidal pulse generator. The latter uses capacitive voltage doubling and spark gap switching. A step-up transformer couples voltage from the pulser to the PLIA coil. Voltage measurements on the coil were made in air using a high-voltage resistive probe, while capacitive probes placed along the length of the PLIA were used to measure wave propagation with the PLIA structure filled with transformer oil. Results: Voltage measurements acquired on the primary and secondary coils of the transformer coupler in air demonstrated a peak-to-peak voltage step-up of 4.2 relative to the pulser DC charging voltage. The maximum voltage time-rate-of-change on the PLIA coil was 0.76 × 1013 V/s. Capacitive probe measurements indicated voltage oscillations on the PLIA coil with half-period equal to 43 ± 0.9 ns and wave speed (with oil) of 1.2 × 107 m/s. Average and peak accelerating gradients were conservatively estimated to be 0.44 and 0.60 MV/m, respectively, with a charging voltage of 55 kV. Wave propagation was demonstrated at these gradients without flashover at a vacuum pressure of 9 × 10-6 Torr. Submerging the pulser in oil would allow for charging voltages up to 150 kV and produce accelerating gradients >1.2 MV/m. Conclusions: Use of a multi-stage, fast PLIA for light ion acceleration could provide a low-cost complement to cyclotrons for the production of short half-life isotopes used for PET imaging, including carbon-11, nitrogen-13, oxygen-15, and fluorine-18.

E-field Measurement of a Pulse Line Ion Accelerator

High-frequency Electric Field Intensity Measurement Based on Frequency Shift with High Gain and Wide Frequency Range

Development and Application of Integrated Optical Sensors for Intense E-Field Measurement.

Electromagnetic wave propagation in a fast pulse line ion accelerator

Study of an Integrated Optical Sensor with Mono-Shielding Electrode for Intense Transient E-field Measurement

Study of measurement techniques for strong pulsed electric field

Measurement of high-power transient electromagnetic pulse field with integrated photonic electric-field sensor

Electric field measurement under AC/DC

Measurement of Carrier-Envelope Phase and Field Strength of A Few-Cycle Pulse by Non-Sequential Double Ionization

Design and application of an integrated electro-optic sensor for intensive electric field measurement

Experimental research of double-pulse linear induction electron accelerator

Micro Optical E-field Sensor for Intense Electric Field Measurement

Novel integrated electro-optic sensor for intensive transient electric field measurement

Design of Wideband GHz Electric Field Sensor Integrated with Optical Fiber Transmission Link for Electromagnetic Pulse Signal Measurement

Design and experiment of broadband electric field sensor for high-power sub-nanosecond pulse measurements

LiNbO3 Crystal Intense Electric Field Sensor Coupled With Twisted Polarization Maintaining Fiber

The Development of Integrated Electro-Optic Sensor for Intensive Electric Field Measurement

Electric Field Measurements in Plasma Based on Electric Field Induced Second Harmonic Generation (E-FISH) with Nanosecond/picosecond Laser

Integrated Photonic Electric Field Sensor Operating More Than 26 GHz

3D power frequency intensive electric field sensor based on a lithium niobate electro-optic crystal

Characterization and analysis of infrared imaging diagnostics for intense pulsed ion and electron beams