Abstract:Acceleration measurement plays an important role in a variety of fields in science and engineering. In particular, the accurate, continuous and non-contact recording of the shock acceleration profiles of the free target surfaces is considered as a critical technique in shock physics. Various kinds of optical interferometers have been developed to monitor the motion of the surfaces of shocked targets since the 1960s, for instance, the velocity interferometer system for any reflector, the fiber optic accelerometer, the photonic Doppler velocimetry system and the displacement interferometer. However, most of such systems rely on the coherent quasi-monochromatic illumination and discrete optic elements, which are costly in setting-up and maintenance. In 1996, L. Levin et al reported an interferometric fiber-optic Doppler velocimeter with high-dynamic range, in which fiber-coupled components were used to replace the discrete optic elements. However, the fringe visibility of the Levin's system is low because of the coupled components, which greatly limits the reliability and accuracy in the shock measurement. In this paper, a compact all-fiber interferometer system for measuring the shock acceleration is developed and tested. The advantage of the system is that not only removes the non-interfering light and enhances the fringe visibility, but also reduces polarization induced signal fading and the polarization induced phase shift. Moreover, it also does not require a source of long coherence length. The system bases entirely on single-mode fiber optics and mainly consists of a polarization beam splitter, a faraday rotator, a depolarizer and a 3x3 single-mode fiber coupler which work at 1310 nm wavelength. The optical systems of the interferometer are described and the experimental results compared with a shock acceleration calibration system with a pneumatic exciter (PneuShock(TM) Model 9525C by The Modal Shop) are reported. In the shock acceleration test, the interferometer system measured shock acceleration with peak accelerations of similar to 100,000 m/s(2) and the durations of similar to 0.2 ms which are conformed to the results of the shock acceleration calibration system. The measured relative error of the acceleration is within 3%.

Velocity test by fiber laser interferometer

Calibration and Correction of Particle Velocity Signals in Optical Fiber Measurement

Application of Fiber Optic Interferometer System in Flyer Plates Velocity Measuring

All-Fiber Configuration Laser Self-Mixing Doppler Velocimeter Based on Distributed Feedback Fiber Laser

Single-mode fiber, velocity interferometry

Modified Homodyne Laser Interferometer Based on Phase Modulation for Simultaneously Measuring Displacement and Angle.

Velocity Measurement Based on Laser Doppler Effect

All Fiber Optical Velocity Interferometer Research

All-fiber heterodyne velocity and displacement interferometer based on DPLL Doppler tracking with sub-nanometer per second and picometer sensitivity

Reconstruction of Velocity Curve in Long Stroke and High Dynamic Range Laser Interferometry

Experimental study on a novel all-fiber vibration velocity interferometer

All-Fiber Velocity Interferometer for Multipoint Measurement

Angular Velocity Measurement System Based on Optical Frequency Comb

A Novel All-Fiber Velocity Measurement System with High Fringe Contrast

Ultralow speed measurement by laser Doppler velocimetry

A Novel All-Fiber Velocity Interferometer Based on Optic-Feedback Delay Line

Fiber-optic Interferometer for Measuring Low Velocity of Diffusely Reflecting Surface

High-velocity measurement method in dual-frequency laser interference tracker based on beam expander and acousto-optic modulator

An Integrated Interferometric Fiber Optic Sensor Using a 638 nm Semiconductor Laser for Air-Water Surface Velocity Measurements

Experimental Study on Zeeman-birefringence Dual-Frequency Laser Interferometer with Mid-Frequency Difference

Compact All-Fiber Interferometer System for Shock Acceleration Measurement