Abstract:The optical frequency comb (OFC) is an emerging laser light source, which has laid the foundation for high resolution, high sensitivity, wide bandwidth and fast measurement. Angular velocity measurement as an important direction in the field of measurement has been paid attention. Nowadays, fibre optic gyroscope (FOG) is usually used to measure angular velocity. The Sagnac effect is the theoretical basis of FOG. Therefore, it is especially important to verify whether the FOG has Sagnac effect. Through theoretical derivation, when the FOG is used as a light source in combination with Sagnac interferometer and the Sagnac interferometer rotates at different angular velocities, the trigonometric function reflects the mutual transformation of the intensity of the light emitted by the interferometer and angular velocities, and the corresponds nonlinear relationship. This proves that FOG has Sagnac effect. When repetition frequency of FOG is locked ,this system can be used to measure angular velocity. In the experiment, we use 1km single-mode fiber as the rotating part of Sagnac interferometer, and measure the light intensity value at 20 different angular velocities. Measuring 10 times at each angular velocity for the mean value, which are used to fit the trigonometric function curve. The results show that the correlation coefficient of the fitting curve is greater than 0.99, and standard deviations of the measurement points are less than 0.06V. The corresponding angle error values at different angular velocities are converted into the distance errors, which are less than 0.032um.

Angular Velocity Measurement System Based on Optical Frequency Comb

Scale Factor Calibration and Dynamic Angle Measurement Method Based on Self-Collimator and Fiber Optic Gyroscope

The New Demodulate Technology of Fiber Optics Gyroscope

Angle error from vibrating in tri-axial interferometric fiber optic gyroscopes and the evaluation with dual-laser Doppler vibrometers

Eigen Frequency Measurements of a Fiber Optic Gyroscope Based on a Staircase Waveform with Large Temperature Range.

Research on Dynamic Performance Evaluation of Fiber Optic Gyroscope Based on Laser Doppler Measurement Technology

One-Dimensional Angle Measurement Error Calibration Technique for Fiber Optic Gyroscope

Angular Random Walk Improvement of a Fiber-Optic Gyroscope Using an Active Fiber Ring Resonator

Design and realization for FOG pure lag test system

Theory And Error Compensation Method Based On The Tilt Sensor Adopted In Dynamic Angle Measurement Of The Fiber Optic Gyroscope

A Dynamic Angle Metrology System Based on Fibre-Optic Gyroscope and Rotary Table

Frequency Characteristic Measurement of a Fiber Optic Gyroscope Using a Correlation Spectrum Analysis Method Based on a Pseudo-Random Sequence

Angular Velocity Measurement with Wide Range Based on Dual-Comb Sagnac Interferometer

A Comparison Angular Vibration Calibration Approach Based on the IFOG

Research on angular vibration measurement system based on heterodyne interference

Optical Acceleration Measurement Method with Large Non-ambiguity Range and High Resolution Via Synthetic Wavelength and Single Wavelength Superheterodyne Interferometry

High-sensitivity Angular Velocity Measurement Based on Bidirectional Coupled Optoelectronic Oscillator

Laser Frequency Noise Power Spectral Density Measurement Technology and Its Application to Resonant Optical Fiber Gyroscope

Experiments by PM Spectroscopy in Resonator Fiber Optic Gyro

Full investigation of the backscattering in resonator fiber optic gyro

IFOG Based on Rhombic Optical Path Difference Bias Configuration for High-Frequency Angular Vibration Measurement