Abstract:The prevention of ice build-up on aircraft surfaces is crucial for safe operations. Thermal ice protection systems, particularly electro-thermal systems, are commonly employed to mitigate ice formation. However, the weight of electric batteries used in these systems significantly impacts aircraft performance, necessitating the minimization of power load during design. Despite this requirement, effective anti-icing operation mandates a sufficient heat flux to maintain surface temperature above the freezing point and evaporate any runback water film. Previous research has utilized numerical simulation analysis to predict the performance of electro-thermal anti-icing systems. The conjugate heat transfer method has been commonly employed to predict temperature distribution on the protected surface. However, non-isothermal surfaces exhibit distinct local convective heat transfer coefficients that influence local thermal balance, unlike isothermal surfaces that adopt the loosely-coupled method for computational efficiency. In this study, we present a novel target temperature-based anti-icing simulation method that predicts the required heat flux for thermal ice protection systems without employing the conjugate heat transfer method. Our objective was to calculate the necessary heat flux to achieve the desired non-isothermal surface temperature for effective anti-icing. By eliminating the excessive iteration process associated with the coupling method for conjugate heat transfer, we have streamlined the simulation procedure. Through validation, target temperature-based anti-icing simulation method, when compared to the tight coupling method, demonstrated the ability to predict the same surface water flow rates while reducing computation time by up to 90 %. Furthermore, when applied to design problems, our method achieved approximately a 10 % reduction in the required heat capacity for anti-icing compared to experimental values. As a result, target temperature-based anti-icing simulation method offers a more efficient alternative to traditional conjugate heat transfer methods, providing valuable insights for both predicting anti-icing system performance and optimizing aircraft design.

Three-dimensional Conjugate Heat Transfer Simulation for the Surface Temperature of Wing Hot-Air Anti-Icing System

A numerical method for two-dimensional nonlinear transient inverse heat conduction problems for orthotropic material

Finite Element Analysis of 3D Heat Transfer of Typical Thermal Bridge of Self-Thermal Insulation in Hot-Summer and Cold-Winter Zone

A Three-Dimensional Fictitious Domain Method for Direct Numerical Simulations of Particle-Laden Flows with Heat Transfer

Validation of Unsteady Thermodynamic CFD Simulations of Aircraft Wing Anti- Icing Operation

Study on Loose-Coupling Methods for Aircraft Thermal Anti-Icing System

Target temperature-based simulation method for predicting performance and designing aircraft thermal anti-icing systems

In-flight anti-icing simulation of electrothermal ice protection systems with inhomogeneous thermal boundary condition

Numerical procedure for electro-thermal anti-icing system simulation coupling internal thermal analysis and external multi-physic code

Investigations on Hot Air Anti-Icing Characteristics with Internal Jet-Induced Swirling Flow

Anti-icing hot air jet heat transfer augmentation employing inner channels

Asymmetric Heat Transfer in Aircraft Electrothermal Anti-Icing

Unsteady simulation of aircraft electro-thermal deicing process with temperature-based method

Numerical Simulation Of Heat And Mass Transfer In Air-Water Direct Contact Using Computational Fluid Dynamics

A new approach to compute heat transfer of ground-coupled envelope in building thermal simulation software

Evaluation of interfacial heat transfer coefficient based on the experiment and numerical simulation in the air-cooling process

Cfd -Based Modelling On Inter Facial Heat Transfer For Water Quenching

Immersed Boundary Method for the Simulation of Flows with Heat Transfer

One-dimension and three-dimension collaborative simulation study of the influence of non-uniform inlet airflow on the heat transfer performance of automobile radiators

Estimation of Surface Temperature and Heat Flux over a Hollow Cylinder and Slab using an Inverse Heat Conduction Approach

Design and calculation of aircraft nacelle anti-icing system