Abstract:The weatherability of weathering steel depends on the protection of the compact rust layers on its surface. However., the compact rust layers might be damaged when they were subject to external actions, for example, collision and scrape etc., which will influence the protective effect on steel base. It is deserved to put attention on further corrosion behavior of the samples with damaged rust layer, which will determine the long term corrosion property. In the present study, electrochemical measurement, metallographic observation and energy disperse spectrum analysis were employed to investigate the further corrosion behaviors of a low carbon bainitic steel in the environment containing Cl-, after its original rust layers had been damaged on different degrees. It was found that the damnification of rust layers on both the low carbon bainitic steel and low carbon steel as a contrast could be rapidly self-repaired in the further corrosion process. When damnification degree and further corrosion time are the same, the resistance and the repair ratio of damaged rust layers on the low carbon bainitic steel are higher than those of the low carbon steel. The fracture toughness of the steel base/rust layer interface of the low carbon bainitic steel is higher than that of the rust layers, so the rust layers would not be abscised thoroughly from the interface and some residual rust would be remained when the steel is subjected to applied actions. The formation of new rust at the damaged sites can be significantly promoted by the residual rust. The contents of Cu and Cr in the original rust layers are close to those in the newly formed rust layers, and both of them are equivalent to those in the steel base. These results indicate that low carbon bainitic steel with excellent mechanical properties and weld ability is a potential candidate for novel weathering steels with higher strength.

EFFECT OF DAMNIFICATION IN RUST LAYER ON CORROSION BEHAVIORS OF LOW CARBON BAINITIC STEEL IN THE ENVIRONMENT CONTAINING Cl-

Effect Of Corroded Surface Morphology On Ultra-Low Cycle Fatigue Of Steel Bridge Piers

Corrosion Behaviors and Mechanical Properties of Q235 Steel Pipes Collapsing Due to Corrosion after 25-Year Service in Urban Industrial Atmospheric Environment

Study On Modulus Of Rust Applied In Steel Corrosion Induced Concrete Cracking Model

Enhancement in Corrosion Resistance of Low-Carbon Steel via Surface Modification

Mechanical Performance of Artificially Rusted Q500MC Structural Steel Subjected to High Temperature

Influence of Carbon Content on Corrosion Resistance Performance of Weathering Steel

Effect of rust layer stabilization on dry and wet cyclic corrosion behavior of bridge weathering steel Q345qNH in simulated industrial atmospheric medium

Investigation of Microstructure and Corrosion Behavior of Weathering Steel in Aqueous Solution Containing Different Anions for Simulating Service Environments

Effect of Chloride-Induced Reinforcing Steel Corrosion on the Flexural Strength of Reinforced Concrete Beams

Corrosion resistance of low-alloy steel in concrete subjected to long-term chloride attack: Characterization of surface conditions and rust layers

High-Temperature Mechanical Properties of Artificially Simulated Corroded Q500MC Structural Steel

Corrosion Micro- and Macro-Electrochemical Behavior of Rusted Carbon Steel and Weathering Steel

On how the corrosion behavior and the functions of Cu, Ni and Mo of the weathering steel in environments with different NaCl concentrations

Corrosion behavior of the low alloy weathering steels coupled with stainless steel in simulated open atmosphere

Experimental study on the corrosion performance of weathering high-strength bolt connections

Deterioration of Mechanical Properties and the Damage Constitutive Model of Corroded Steel in an Industrial Environment

Effect of Heat Treatment on the Passive Film and Depassivation Behavior of Cr-Bearing Steel Reinforcement in an Alkaline Environment

Corrosion-induced mechanical properties of shear bolted connections in high-strength weathering steel

Optimizing the corrosion performance of rust layers: role of Al and Mn in lightweight weathering steel

Comparative investigation of the effect of corrosion on the mechanical properties of different parts of thin-walled steel