Response of Two-Disk Rotor with Squeeze Film Dampers and its Variation with Parameters

tao sun,wei yang qin,xu dong jiao

DOI: https://doi.org/10.4028/www.scientific.net/AMM.117-119.369

2012-01-01

Abstract:This paper investigated the variation of dynamical response of a low pressure rotor in turbo-shaft engine with its system parameters. Based on the model of low pressure rotor, a dynamical simplified model of two-disk rotor with Squeeze Film Damper at each end was built. Its motion equations were derived. The numerical method was applied to solve the 12-dimensions differential equations. The influence of some parameters, e.g., rotating speed, eccentricity and its phase angle, mass ratio of two disks, were analyzed. From simulation results, it can be seen that when phase difference of two disks' eccentricity is pi, the two disks have their minimum vibration amplitude respectively. When their phase is identical, their vibration responses reach maximum values. The larger the mass of mid-span disk is, the larger the vibrations of two disks are. When mass of mid-span is lesser than that of overhung rotor, the response of system will decrease. Squeeze Film Damper(SFD) can reduce vibration in rotor system effectively and has been used in many practical aero-engine. Many researcher works have been conducted on its influence on rotor. And furthermore, some new types of SFD were presented to enhance its effectiveness in suppressing vibration. San Andres([1]) considers a rigid rotor mounted on a pair of flexure pivot TPJBs in series with Integral SFDs and do tests on it to determine the combined effect of these elements on the location of critical speeds and estimation of the rotor-bearing system damping ratio. The tests show rotor-bearing system remained stable in the entire range of operation and without the appearance of subsynchronous vibration or nonlinear damper jump response. Hai([2]) applied impulsive receptance method(IRM) and receptance harmonic balance method (RHBM) to analyze vibration of a realistically sized representative three-shaft whole aero-engine model subject to unbalance excitation from all three rotors. The results show that the use of suitably preloaded vertically oriented bump-springs at the SFDs of the heavy LP rotor produced a significant improvement in journal lift, allowing for smoother running of the shaft. The results obtained also give a better understanding of the interaction between the SFDs and rotors in an aero-engine assembly. Delgado([3]) presented experiments to characterize the forced response of an open ends SFD subject to dynamic loads with multiple frequencies, as in a jet engine intershaft damper. Mendez([4]) advanced a new model able to estimate the performance of finite length SFDs with free air entrainment. Waleed([5]) devoted his work to the fabrication and investigation of SFD. Results showed that the vibration amplitude of the steel damper was lower than Glass/epoxy dampers with the same L/D ratio. Ma([6]) developed a squeeze film damper with valvular metal rubber squeeze film ring (SFD/VMR) for more effective and reliable vibration control, and especially for improving the blade loss dynamics of high-speed rotors based on the conventional SFD. In this paper, we consider a low pressure rotor supported on elastic SFD at both ends. The motion equations are derived by theoretical method and solved by numerical method. Some parameters' influence on rotor vibration is studied.